TiO2/SiO2 composites were synthesized via a simple sol gel method by surface reduction of Ti4+ ions to Ti3+ using titanium isopropoxide as a TiO2 precursor and rice husks (RHA) as a SiO2 source. The silica content and calcination temperature of the materials were evaluated. Thermal, crystallographic and physicochemical aspects suggest that biogenic silica (SiO2) can improve the thermal stability of the anatase phase of TiO2, when the SiO2 content reaches 20%. The N2 adsorption-desorption isotherms showed that the SiO2-modified samples have uniform pore diameters and a large specific surface area. The XPS analysis showed the surface reduction of Ti4+ ions to Ti3+ within the TiO2 network via oxygen vacancies after SiO2 introduction, which is beneficial for the photocatalytic reaction. Photocatalytic degradation of sodium diclofenac (SDFC) shows that TiO2/SiO2 composites have better activity compared to commercial P25. Mesoporous TiO2 composite modified with 20 wt% SiO2 showed better photocatalytic mineralization than P25 (83.7% after 2 h instead of 57.3% for P25). The excellent photocatalytic mineralization of the photocatalysts can be attributed to the high anatase crystallinity exhibited by XRD analysis, high specific surface area, surface hydroxyl groups, and the creation of oxygen vacancy, as well as the presence of Ti3+ ions.
22 June 2024 in Journal of Photochemistry and Photobiology A: Chemistry
Au/TiO2 photocatalysts were studied, characterized, and compared for CO2 photocatalytic gas-phase reduction. The impact of the nature of the TiO2 support was studied. It was shown that the surface area/porosity/TiO2 crystal phase/density of specific exposed facets and oxygen vacancies were the key factors determining CH4 productivity under solar-light activation. A 0.84 wt.% Au/TiO2 SG (Sol Gel) calcined at 400 °C exhibited the best performance, leading to a continuous mean CH4 production rate of 50 μmol.h−1.g−1 over 5 h, associated with an electronic selectivity of 85%. This high activity was mainly attributed to the large surface area and accessible microporous volume, high density of exposed TiO2 (101) anatase facets, and oxygen vacancies acting as reactive defects sites for CO2 adsorption/activation/dissociation and charge carrier transport.
This study explores various approaches to enhancing the activity and selectivity of gas-phase photocatalytic CO 2 reduction under humid conditions by implementing and optimizing bimetallic M–Cu systems (M = Pt, Pd, Au, Ag) supported on titanium dioxide (TiO 2 ). By tuning the total metal content, the molar ratio between M and Cu, the deposition method, and the nature of the TiO 2 support, it is possible to create a synergy between copper and the secondary metal, each contributing its own advantages while minimizing drawbacks. This strategy also improves the stability of the systems by increasing their resistance to Cu oxidation. These results offer a promising pathway for the development of efficient photocatalysts for solar-driven gas-phase CO 2 conversion into chemical fuels.