The hydrogenation mechanism of nitrobenzene to aniline on Pd3/Pt(111) surface preferentially follows the direct route and fits best the Jackson reaction mechanism (mechanism B).
A series of novel organic–inorganic nanoscale layered materials were synthesized by intercalating the Ti-containing Schiff base complex into the interlayer of the ZnM layered double hydroxides (LDHs, M = Al, Cr, Fe, Ce). The hybrid material was further calcined to make metal oxide composites with highly dispersed Ti elements (Ti/ZnO–MxOy). The structural characterization and photocatalytic results showed that, after intercalation and calcination, the metal oxide composites with a unique flower-like crystal morphology not only had high specific surface area, uniform pore size distribution and narrow band gap, but also showed extremely high photocatalytic performance for hexachlorobenzene (HCB) degradation. The Ti/ZnO–Cr2O3 composite with the narrowest band gap (2.40 eV) and the highest surface area (227 m2) showed the highest photocatalytic performance for HCB (95.5% within 240 min) among the four metal oxide composites. Particularly, it was found that composites derived from layered materials with different supramolecular structure of the host and guest showed different photocatalytic properties. In addition, based on the results from ESR, GC-MS and HPLC-MS, the type and amount of hydroxyl radicals, the decomposition intermediates and the pathway of HCB degradation photocatalyzed by Ti/ZnO–MxOy composites are also discussed in detail.
In this paper, Au–Co/Ni bimetal supported layered double hydroxides (Au–Co,Ni/LDHs) were synthesized for the hydrogenation reaction of crotonaldehyde (CDE) to crotonyl alcohol (COL) with both high conversion and selectivity under light irradiation. The hydrogenation experimental results indicated that both the hydrogenation conversion of CDE and the selectivity of COL have been greatly improved by Au–Co,Ni/LDHs under visible light irradiation, with the best turnover frequency performance of 189 h−1, 100% conversion and 99.1% selectivity (using Au–Ni/LDHs). Such high properties are attributed to a synergistic effect of localized surface plasmon resonance (LSPR) of Au nanoparticles, and the additional Co or Ni species would further enhance this effect. The DFT calculation of CDE hydrogenation at Au–Co,Ni/LDHs showed that the hydrogenation happens at C2O1 first to produce COL by following mechanism A2. Au–Ni/LDHs with lower activation energy had higher catalytic activity than Au–Co/LDHs. Further calculation showed that the COL hydration reaction can be hindered on Au–Co,Ni/LDHs compared to the unmodified Au/LDHs, which indicates that the introduction of second metal Ni or Co besides Au could further increase the COL productivity. The DFT calculations well explained and supported the experimental results.