Water-soluble fluorescent carbon dots (CDs) were synthesized by a hydrothermal method using citric acid as the carbon source and ethylenediamine as the nitrogen source. The repeated and scale-up synthetic experiments were carried out to explore the feasibility of macroscopic preparation of CDs. The CDs/Fe³⁺ composite was prepared by the interaction of the CDs solution and Fe³⁺ solution. The optical properties, pH dependence and stability behavior of CDs or the CDs/Fe³⁺ composite were studied by ultraviolet spectroscopy and fluorescence spectroscopy. Following the principles of fluorescence quenching after the addition of Fe³⁺ and then the fluorescence recovery after the addition of asorbic acid, the fluorescence intensity of the carbon dots was measured at λex = 360 nm, λem = 460 nm. The content of ascorbic acid was calculated by quantitative analysis of the changing fluorescence intensity. The CDs/Fe³⁺ composite was applied to the determination of different active molecules, and it was found that the composite had specific recognition of ascorbic acid and showed an excellent linear relationship in 5.0–350.0 μmol·L⁻¹. Moreover, the detection limit was 3.11 μmol·L⁻¹. Satisfactory results were achieved when the method was applied to the ascorbic acid determination in jujube fruit. The fluorescent carbon dots composites prepared in this study may have broad application prospects in a rapid, sensitive and trace determination of ascorbic acid content during food processing.

Sweet cherry has many cultivars with different storability and nutritional properties. To reveal the reasons for the differences in storability among cultivars and improve the quality of sweet cherries, the surface microstructure of four representative sweet cherry cultivars (Red Light, Ranier, Red Agate, Friendship) epidermis and peduncle at harvest were examined and the effects of carboxymethyl chitosan-gelatin (CMCS-GL) based edible coating incorporating CaCl₂ and ascorbic acid (AA) (AA-CaCl₂-CMCS-GL) on the quality and nutritional characteristics of sweet cherry were evaluated. Results showed there were significant differences in the wax distribution of the epidermis and the number of stomata on the peduncle surface between four cultivars of sweet cherries at harvest, which was closely related to fruit decay ratio during storage. AA-CaCl₂-CMCS-GL coating delayed the onset of decay and the fruit decay ratio in coated groups (3.0%–15.3%) was significantly lower than in control groups (17.7%–63.0%) after 33 d storage. The coating also helped to maintain the quality and nutritional characteristics of four sweet cherry cultivars, including reducing weight loss, maintaining better skin color, peduncle freshness, higher fruit firmness, titratable acidity, AA, total phenolics content, total anthocyanins concentration, and antioxidant capacity. These results suggested that AA-CaCl₂-CMCS-GL coating could be considered as a new preservation method for improving postharvest quality and nutritional properties of different sweet cherry cultivars.

Fresh jujube is prone to rapid deterioration after harvest due to its active metabolism and rich nutrients. This study aimed to investigate the effects of acidic electrolyzed water (AEW), a high-voltage electrostatic field (HVEF) and a combination of AEW and HVEF (AEW + HVEF) treatments on the storage quality of Huping jujube (Ziziphus jujuba Mill. cv. Huping) stored at 0 ± 1 °C for 90 days. The results showed that the fruits treated with AEW + HVEF exhibited better storage quality than those treated with either AEW or HVEF alone. Specifically, the fruits treated with AEW + HVEF maintained higher levels of nutrients and taste compounds, including total soluble solid (TSS), total soluble sugar, reducing sugar and titratable acidity (TA), as well as lower respiration rate, weight loss, decay index and TSS/TA ratio. Additionally, the AEW + HVEF treatment could delay the increase in reddening index, a* and color change (ΔE) values, and the decrease in L* and b* values, by retarding the degradation of chlorophyll and accumulation of carotenoids and flavonoids, thereby preserving the more desirable appearance color. Furthermore, the combined treatment could enhance the glutathione reductase (GR) activity and 2,2′-azino-bis-(3-ethylbenzothizoline)−6-sulfonic acid (ABTS) +-scavenging ability. Thus, the AEW + HVEF treatment is a potential method for Huping jujube preservation.

Edible coatings have attracted the attention of researchers in recent years due to their degradability, safety, non-toxicity, low cost, good preservation effect, and other advantages. To prepare a new edible film with good mechanical and barrier properties, carboxymethyl chitosan (CMCS) and gelatin (GL) were selected as the film-forming matrix in this experiment, and glycerol, CaCl₂, Tween-20, and ascorbic acid (AA) have been added as plasticizers, crosslinking agents, surfactants, and antioxidants. Crosslinking agents and antioxidants first, the film was prepared by the casting method, and single factor tests were used to compare the effects of different CMCS: GL (w:w), glycerol, CaCl₂, Tween-20, and AA on mechanical properties (Tensile Strength (TS), Elongation at break (EAB)) and barrier properties (Water Vapor Permeability (WVP), Oxygen Permeability (OP)). Then, the weighting of each performance index is determined by a combination of principal component analysis and the comprehensive membership evaluation method. The formula for calculating the overall rating of edible film performance was determined. Finally, the manufacturing process of edible film with better performance was optimized by a response surface test. The results showed that the influence of each factor on the performance of the edible film was as follows: Glycerol addition > CaCl₂ addition > CMCS:GL, Tween-20, and AA had no significant influence on the performance of the edible film. When calculating the overall edible film property score, the weights of TS, EAB, WVP, and OP were 0.251, 0.068, 0.334, and 0.347, respectively. The optimal formulation for an edible film based on CMCS-GL with better properties than pure CMCS and GL film was CMCS:GL = 2:1, with the addition of 1% glycerol, 2% CaCl₂, 0.1% Tween-20, and 2% AA. The TS, EAB, OP, and WVP of the film obtained with this formula were: 16.28 MPa, 71.46%, 1.39 × 10⁻¹² g·cm/(cm²·s·Pa), 5.10 × 10⁻¹¹ cm³·cm/(m²·s·Pa), respectively. This study suggests that CMCS-GL-based edible coatings can be used as a new food packaging material.

Patulin (PAT) is a fatal mycotoxin that exerts serious threats to human and animal health. Biodegradation of PAT is considered to be one of the promising ways for controlling its contamination. In this study, Lactiplantibacillus plantarum 6076 (LP 6076) with reliable removal efficiency on PAT was screened out from three lactic acid bacteria (LAB) strains. It was found that the PAT was eliminated through degradation by LP 6076, and the intracellular proteins played a crucial role in PAT degradation with the induction of PAT. The proteomic analysis showed that the response of LP 6076 to PAT was by a concerted effort to repair DNA damage, in parallel to adaptive changes in cell wall biosynthesis and central metabolism. Eleven differentially expressed proteins with high fold changes were picked out and identified as PAT degradation candidate enzymes. The 3D structures of the candidate enzymes were predicted, and molecular docking between the enzymes and PAT was performed. Five enzymes, including Acetoin utilization AcuB protein (AU), GHKL domain-containing protein (GHLK), Dihydroneopterin aldolase (DA), YdeI/OmpD-associated family protein (YDEL), and Transcription regulator protein (TR), could dock with PAT with lower affinity and shorter distance. Through molecular docking analysis, DA was ultimately identified as a potential key degrading enzyme. The choice of DA was substantiated by its superior combination of strong binding affinity and a productive binding pose with PAT. VAL84 and GLN51 residues of DA were likely the active sites, forming four hydrogen bonds with PAT. Our study could accelerate the commercial application of biodegradation toward PAT decontamination.

To prepare an edible coating with a good preservative effect on sweet cherries, carboxymethyl chitosan (CMCS) and gelatin (GL) were selected as the film-forming matrix in this experiment, and CaCl2 and ascorbic acid (AA) were added as crosslinking agents and antioxidants, respectively. First, the film was prepared by the casting method, and the film formula with better mechanical and barrier performance was filtered out by one-factor and response surface optimization test, and the differences in the preservation effect of different film formulations (CMCS-GL, CaCl2- CMCS-GL, AA -CaCl2- CMCS-GL) on sweet cherries were compared. and then the different film formulations were compared. The difference in film formulation on the preservation effect of sweet cherries was investigated. The results showed that the optimal formulation for an edible film based on CMCS-GL with good performance was CMCS: GL (w:w)=2:1, with the additional amount of 1% glycerol, 2% CaCl2, 0.1% Tween-20, 2% AA, the tensile strength, elongation at break, oxygen permeability and water vapor permeability of the film obtained with this formula were: 16.28 MPa, 71.46%, 1.39×10-12 g- cm/(cm2-s-Pa), 5.10×10-11 cm3-cm/(m2-s-Pa), respectively. In the preservation of sweet cherries, all three film formulations effectively reduced the rotting rate and weight loss during storage while preserving the high hardness and skin color of the fruit. Among them, the formulation AA -CaCl2- CMCS-GL showed the best preservation effect and can be used as a new method for postharvest preservation of sweet cherries.