With the advancement of the use of geophysical methods in mining exploration, the possibility of restudying known mineral deposits that could have greater potential than that previously estimated is opening up, as is the case in the Maricunga Belt (MB), which is a metallogenic belt located east of Copiapó, Chile, with a length of 200 km and oriented in the NNE-SSW direction. This belt hosts significant gold deposits classified as porphyry gold (-copper), epithermal gold (-silver) of a high sulphidation type, and transitional gold, in some districts. In this work we studied the characteristics of the MB through local earthquake tomography (LET), which revealed a clear spatial correlation between low Vp/Vs anomalies and the gold deposits, demonstrating that lithologic interpretation using Vp and Vs values of the seismic tomography makes sense for the most common rocks associated with the genesis of porphyry-type deposits. Furthermore, high Vp/Vs anomalies were correlated to the main regional faults around the study zone, which seem to have a robust structural control regarding the location of the deposits.

We present an updated and validated seismic catalog for the northern Fennoscandian region, focusing on postglacial faults from the Merasjärvi fault system in the southwest to the Iešjávri fault system in the northeast. This work involved a comprehensive review of continuous waveforms derived from open datasets from 2007 to 2015 and processed using the Regressive ESTimator algorithm. The primary objective was to refine the delineation of seismicity along the above-mentioned postglacial faults and highlight their seismic potential. Our analysis revealed distinct waveform patterns originating primarily from two main sources: approximately 15% were associated with areas mapped as postglacial faults, and the remainder of the events outside these areas, 89%, were concentrated in areas with active mines. Compared to previously reported events in the Fennoscandian Earthquake Catalogue (FENCAT), we observed a 22% increase in seismic activity within postglacial fault zones. These results demonstrate that the Regressive ESTimator algorithm not only improves the detection of tectonic seismicity but also effectively identifies seismic signals resulting from mining activities in the study area. The Merasjärvi, Lainio–Suijavaara, Palojärvi, and Maze and Iešjávri fault systems appear to form a continuous deformation complex of approximately 300 km long, which we propose naming the Merasjärvi–Stuoragurra fault complex.