Abd Al Karim Jaafar

Dr. Abd Al Karim Jaafar

soil sciences, Damascus University, Damascus, Dimashq, Syrian Arab Republic
orcid

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
23 December 2023 in Journal of Environmental Management
Verified
Journal Article
Open access
JKJehan Khalil
Jehan Khalil
Abd Al Karim JaafarAbd Al Karim Jaafar
Abd Al Karim Jaafar
HHHassan Habib
Hassan Habib
SBSirine Bouguerra
Sirine Bouguerra
VNVerónica Nogueira
Verónica Nogueira
Andres Rodríguez-SeijoAndres Rodríguez-Seijo
Andres Rodríguez-Seijo
Olive oil mill wastewater (OMW) is an environmental concern in olive oil producers' regions due to its use in agricultural soils as an organic amendment. However, OMW can also be used as organic fertilizer due to their high organic matter and nutrient levels, but its use, when it occurs without environmental management, can cause serious environmental implications for soils and waters. This work evaluated the impact of different OMW levels on a set of physicochemical parameters from an agricultural vertisol where wheat grew (Triticum aestivum L var. Douma 1). A set of physicochemical parameters were conducted before adding different levels of OMW (0, 5, 10 and 15 L m-2) at two soil depths (0-30 and 30-60 cm) and for the two growing seasons to determine: i) the effect of OMW treatments on the studied physicochemical soil properties (bulk density, soil porosity, soil pH, electrical conductivity and organic matter), ii) available primary (N, P, K) and secondary macronutrients (Ca, Mg and Na), ii) micronutrients (Cu Fe, Mn and Zn), and iv) available heavy metals (Cd and Pb). The results indicated that soil physicochemical parameters were slightly improved, mainly due to improvement in organic matter, macro- and micronutrients, usually proportionally to the olive mill wastewater dose. Cadmium and Pb were within the permissible limits. The increased OMW had different behaviour on the soil nutritional balances of different elements, leading to nutrient imbalances, although in some cases, they were improved. However, the plant growth was not affected, and it was improved under 10 L m-2 and 15 L m-2 doses. The results offer valuable data about the use of OMW as organic fertilizer for crops and their potential impact on soil properties.

30 May 2025 in Archives of Agronomy and Soil Science
Verified
Journal Article
Open access
LGLongkat Ayuba Gufwan
Longkat Ayuba Gufwan
NGNkiruka May Gufwan
Nkiruka May Gufwan
Mukhtar Iderawumi AbdulraheemMukhtar Iderawumi Abdulraheem
Mukhtar Iderawumi Abdulraheem
Abd Al Karim JaafarAbd Al Karim Jaafar
Abd Al Karim Jaafar

1 February 2025 in EDRAAK
Verified
Journal Article
Open access
PDF file
Hussein AlkattanHussein Alkattan
Hussein Alkattan
Benson TURYASINGURABenson TURYASINGURA
Benson TURYASINGURA
BWByamukama Willbroad
Byamukama Willbroad
Abd Al Karim JaafarAbd Al Karim Jaafar
Abd Al Karim Jaafar
This research investigates the classification of Iraq's economic performance from 2000 to 2023 using machine learning methodologies, specifically Support Vector Machines (SVM) and Random Forest (RF). The study aims to leverage macroeconomic indicators to develop predictive models for economic state classification. The dataset comprises six key variables gross domestic product, inflation rate, unemployment rate, exchange rate, trade volume, and government spending selected for their economic relevance. The methodology employs a composite Economic Performance Index for binary categorization ("Good" or "Poor"), followed by the application of SVM and RF algorithms. Model performance is evaluated using metrics such as AUC, F1-score, precision, recall, and MCC. Results indicate that SVM demonstrates superior classification accuracy compared to Random Forest, highlighting its effectiveness in capturing complex economic relationships. Gross domestic product, inflation, and government spending are identified as the most influential factors. This research contributes to the growing intersection of machine learning and macroeconomic forecasting, providing policymakers with data-driven insights for economic policy evaluation.

13 June 2025 in Discover Applied Sciences
Verified
Journal Article
Open access
PDF file
MAMaher Al-Eid
Maher Al-Eid
AQAhmad Qabatty
Ahmad Qabatty
RKRayad Kubaisi
Rayad Kubaisi
Abd Al Karim JaafarAbd Al Karim Jaafar
Abd Al Karim Jaafar
This study was conducted at the Faculty of Agriculture, Damascus University, to investigate the effect of sieve hole diameter, number of hammers, and concave clearance on the efficiency of a locally manufactured hammer mill. Three levels of sieve hole diameters (D3: 3 mm, D4: 4 mm, and D5: 5 mm), three levels of hammer numbers (N24: 24, N26: 26, and N28: 28 hammers), and two levels of concave clearance (C5: 5 mm and C10: 10 mm) were evaluated. Their impact on ground corn productivity, energy consumption, machine efficiency, and compression ratio was assessed. Results were analyzed using Exstate 2014 software, and differences between treatment means were tested using the Least Significant Difference (LSD) test at a significance level of 0.05, with three replications. The results showed that increasing sieve hole diameter from D3 to D5 and reducing concave clearance from C10 to C5 significantly enhanced productivity (an increase of 52.13% for D5 compared to D3) and machine efficiency. Conversely, energy consumption decreased. Moreover, reducing sieve hole diameter and increasing the number of hammers led to a higher compression ratio and increased energy consumption. The optimal parameters for grinding corn using the tested hammer mill were a sieve hole diameter of D5 (5 mm), a concave clearance of C5 (5 mm), and N26 (26 hammers). This combination resulted in 938.5 kg/h productivity, acceptable energy consumption of 2948 W, and machine efficiency of 96%. Additionally, the optimal compression ratio (38%) was achieved when using a sieve hole diameter of D3 (3 mm), concave clearance of C5 (5 mm), and N28 (28 hammers).

1 January 2025 in Phyton
Verified
Journal Article
Open access
PDF file
Abd Al Karim JaafarAbd Al Karim Jaafar
Abd Al Karim Jaafar
SSSuleiman Salim
Suleiman Salim
DADema Altheb
Dema Altheb
Mukhtar Iderawumi AbdulraheemMukhtar Iderawumi Abdulraheem
Mukhtar Iderawumi Abdulraheem
Andres Rodríguez-SeijoAndres Rodríguez-Seijo
Andres Rodríguez-Seijo
The use of organic fertilizers can be an opportunity to increase crop yield and improve soil fertility in semi-arid regions, since soils from these regions usually have unfavourable conditions for plant growth. This research investigates the effects of organic and mineral fertilization on the impact of soil properties (pH, electrical conductivity and organic matter), availability of macro- (N, P and K), micro-nutrients (Fe, Mn, Cu and Zn) and the accumulation of heavy metals (Pb, Cd, Cr) in soil and potato tubers grown under semiarid conditions. A field experiment was conducted in Raqqa Governorate (Syria) using a randomized complete block design with six treatments: control, mineral fertilizer, fermented cow manure, municipal compost, sewage sludge and olive oil solid waste. At harvest, soil and plant samples were analyzed to assess nutrient dynamics in the soil and potato tubers, including metal uptake. The results showed that the highest yields were obtained with mineral fertilizer (22.87 t ha−1) and sewage sludge (22.15 t ha−1). Organic amendments significantly improved soil organic matter, total nitrogen, and the bioavailability of phosphorus, potassium, and micronutrients after harvest. Compost and sewage sludge notably enhanced the soil and plant contents of Mn and Cu. However, these amendments also increased the amounts of Pb and Cd in soils and their uptake by plants, with Cd contents exceeding the Codex Alimentarius limit for potatoes (>0.1 mg kg−1). These findings highlight the potential of treated organic waste as a valuable nutrient input for potato cultivation, especially in resource-limited areas. However, continuous monitoring is required due to the risk of heavy metal accumulation. Integrating organic fertilizers with mineral sources appears to be an effective strategy for improving crop productivity, soil health, and environmental sustainability.

10 July 2024 in Eurasian Soil Science
Verified
Journal Article
Closed access
PDF file
RAR. Al-Khoury
R. Al-Khoury
Abd Al Karim JaafarAbd Al Karim Jaafar
Abd Al Karim Jaafar
SSS. Salim
S. Salim
Saglara S. MandzhievaSaglara S. Mandzhieva
Saglara S. Mandzhieva
ABA. Barakhov
A. Barakhov
Vishnu D. RajputVishnu D. Rajput
Vishnu D. Rajput
The present work was conducted to evaluate the chromium contamination and its relationship with soil components of the Eastern Ghouta of Damascus, Syria. Various areas were chosen in the terms of chromium content analysis. Soil samples were collected from these areas to a depth of 60 cm from the three layers, at intervals of 20 cm. The results showed that the levels of total and CrVI were within the normal limits in Al-Maamouniye (uncontaminated with chromium), Jobar (agricultural land), and Ein Tarma (agricultural land). While it exceeded the maximum permissible limit (MPL) as per FAO and WHO on the area of Tanneries (Dabagat). The soil content of CrIII (536.99, 474.34, 415.77 mg kg–1) and CrVI (0.12, 0.51, 0.75 mg kg–1) were determined in the layers of 0–20, 20–40, 40–60 cm, respectively. The results also showed that 80% of chromium was associated with organic matter in the soil of Al-Dabagat region. In contrast, approximately 85% of chromium was available in the remaining part of the Mamounia soil. It was noted the content of chromium, which is associated with iron and manganese oxides, were high. Although chromium was exchangeable and bounded to CaCO3, however, its quantity was negligible. The results showed that the concentration of CrVI increased with depth at all the selected areas, in contrast to CrIII which decreased with the depth of soils.