The objective of this study was to design the die groove profile and predict the rolling force produced when employing the variable curvature rolls and mandrel for manufacturing seamless pipes using the cold pilger rolling process. The parameters of the key process design were the diameter of the initial tube and final product, as well as the feed amount, reduction area, principal deformation zone, and roller radius. The rolling forces during the pilger rolling process were theoretically calculated to enable their prediction, and the characteristics of the cold pilger rolling process were identified. The calculated values were in close agreement with the experimental data. The die groove design is important in the prediction process because the dimensional accuracy of the tubes and the life of the dies are highly dependent on this design. The presented design method can be successfully applied to fulfill this objective. The tube shape and adequate tolerance can be attained by using the proposed design method. The mechanical properties of the pipe are evaluated by calculating the Q factor.

The multi-pass shape drawing process is mainly used in metal forming processes to manufacture long components with constant arbitrary cross-sectional shapes along their lengths. The cross-roller guide is a typical component that is manufactured by a multi-pass shape drawing process. The cross-roller guide is mostly used in optical measurement equipment where high-precision movement is required. Therefore, the dimensional accuracy of the cross-roller guide is very important since it can influence precision linear motion. However, the unfilled defects can occur in a case where the product has a complex cross-sectional shape. In this study, a new design method for an intermediate die is suggested by using an equal-radial-velocity variation method in order to reduce the unfilled defects. The proposed design method can reduce the unfilled defects by minimizing the radial velocity variation in the deformation zone of the drawing die. The intermediate die was designed by geometrical information of the final product without prior finite element (FE) analysis. The suggested method was applied to design the multi-pass shape drawing process for manufacturing the cross-roller guide. FE analysis was performed to validate the effectiveness of the proposed method in comparison to the conventional design method that uses equipotential lines in the multi-pass shape drawing process. Finally, a shape drawing experiment was performed to compare the target shape and the FE analysis with the experimental data.