As a strong candidate for future electronics, atomically thin black phosphorus (BP) has attracted great attention in recent years because of its tunable bandgap and high carrier mobility. Here, we show that the transport properties of BP device under high electric field can be improved greatly by the interface engineering of high-quality HfLaO dielectrics and transport orientation. By designing the device channels along the lower effective mass armchair direction, a record-high drive current up to 1.2 mA/μm at 300 K and 1.6 mA/μm at 20 K can be achieved in a 100-nm back-gated BP transistor, surpassing any two-dimensional semiconductor transistors reported to date. The highest hole saturation velocity of 1.5 × 107 cm/s is also achieved at room temperature. Ballistic transport shows a record-high 36 and 79% ballistic efficiency at room temperature and 20 K, respectively, which is also further verified by theoretical simulations.
Two-dimensional van der Waals materials offer various possibilities for synaptic devices, matching the requirements of intelligent and energy-efficient computation. However, very few studies on robust flexible synaptic transistors have been reported, which hold great potential for soft robotics and wearable applications. Here a floating gate synaptic device based on ambipolar black phosphorus (BP) on a flexible substrate has been demonstrated with two working modes. The three-terminal mode, where the carriers are injected into the floating gate, shows a nonvolatile memory effect, whereas the two-terminal mode shows a quasi-nonvolatile memory effect. Remarkably, the synaptic device working on the three-terminal mode shows an excellent performance in the energy-efficient computation of sub-fJ/spike with a fast gate voltage response down to ∼10 ns. Furthermore, the flexible synaptic device exhibits good endurance under 5,000 bending cycles with a strain of ∼0.63%, suggesting great potential in flexible neuromorphic applications with low energy consumption.
Monolayer molybdenum disulfide (MoS2) is a promising semiconductor channel material for future electronics due to its atomic thickness and high mobility. However, conventional back-gate MoS2 transistors suffer from substantial scattering caused by substrate and surface adsorbates, which impair carrier mobility and device reliability. In this work, we demonstrate an exemplary dielectric engineering approach that uses atomic-layer-deposited hafnium oxide (HfO2) as the gate dielectric and channel passivation layer to improve device performance and positive bias instability. The large-single-crystal monolayer MoS2 film was directly synthesized on SiO2/Si substrates by a low-pressure chemical vapor deposition method. MoS2 transistors with various dielectrics were fabricated and characterized for a fair comparison. The mobility increased from 4.2 to 19.9 cm2/V·s by suppressing charged impurities and phonon scattering when transferring the MoS2 channel from 100 nm SiO2 substrates to 20 nm HfO2 substrates. Passivation of another 10 nm HfO2 on the back-gate transistors further increased the mobility to 36.4 cm2/V·s with a high drive current of 107 μA/μm. Moreover, the threshold voltage shift of the passivated transistor was reduced by about 58% from 1.9 to 0.8 V under positive bias stress. This is due to the fact that channel passivation with HfO2 effectively eliminated charge trapping of adsorbed substances. These results reveal that HfO2 gate dielectric and passivation by atomic-layer deposition are effective methods to improve the performance and stability of MoS2 devices.
Edge contact is essential for achieving the ultimate device pitch scaling of stacked nanosheet transistors with monolayer 2-dimensional (2D) channels. However, due to large edge-contact resistance between 2D channels and contact metal, there is currently a lack of high-performance edge-contact device technology for 2D material channels. Here, we report high-performance edge-contact monolayer molybdenum disulfide (MoS 2 ) field-effect transistors (FETs) utilizing well-controlled plasma etching techniques. Plasma etching with pure argon improves the edge dangling bonds and thus improves the edge-contact quality. Edge-contact monolayer MoS 2 FET shows good ohmic contact even at cryogenic temperatures (20 K), achieving a record-low contact resistance ( Rc ) of 1.25 kΩ·μm among all edge-contact MoS 2 devices. The record-high on-state current of 436 μA/μm and transconductance of 123 μS/μm at Vds = 1 V are achieved on an edge-contact monolayer MoS 2 FET with Lch = 120 nm. This work highlights the great potential of edge contacts for high-performance monolayer transition metal dichalcogenide (TMD) material electronics.