Lanthanum doped SiC nanowires (La-doped SiC NWs) were prepared using the chemical vapor reaction technique at different heat preservation times. Polycarbosilane was employed as a provider of both the Si and C elements. The characterization results suggested that the products were β-SiC. The nanowires straightened, the diameter of the nanowires became larger, and the content of La reduced with increasing heat preservation time. Meanwhile, the coating layer of SiO2 obviously dwindled. The XPS spectrogram revealed that the existence of the element La in the product was in the form of a trivalent ion, La3+. The forbidden band width dropped from 1.37 to 0.8 eV after doping with La, which was calculated using Material Studio 4.2 software. When a heat preservation time of 120 min was used, the content of La had a minimum of 0.87 at%, and the turn-on field and the threshold field of the product were 1.2 and 5.0 V μm−1, respectively. A synergetic influence mechanism was put forward to explain the effects of the morphology and the La content on the field emission (FE) properties of the La-doped SiC NWs. This work could act as a reference article for those researching FE properties of other one-dimensional nano-materials.
Nonlinear optical absorption effect in KDP and 70%-DKDP crystals, which were grown by the conventional temperature cooling method, was systematically studied using picosecond pulse laser excitation. Using open aperture Z-scan measurements, the dependence of nonlinear absorption effect on sample orientations (I, II, and z) as well as laser intensity was systematically measured at λ = 1064 and 532 nm. According to the experimental results, the nonlinear absorption effect at λ = 532 nm was confirmed, while at λ = 1064 nm no nonlinear absorption was observed for KDP and 70%-DKDP crystals. In addition, the optical absorption along I- and II-type affected by laser intensity was larger than that along the z-direction. The important nonlinear absorption coefficients β and (esu) measured along different orientations were exhibited in detail at wavelengths of 1064 nm and 532 nm. The results indicate that nonlinear absorption coefficients increase first and then decrease with the increment of laser intensity for KDP and 70%-DKDP crystals.
Potassium dihydrogen phosphate crystals were grown around 65 °C. The growth rate of KDP (KH2PO4) crystal prismatic faces was measured by laser polarization interference system. The surface micro morphology of KDP crystals grown at various supersaturation were comparatively observed by atomic force microscope systematically. The results show that the growth rate increased with the rise of supersaturation, the aspect ratio reduced. The steps bunching height occurred at σ = 0.03 and 0.04. At this point, the steps height reached maximum value about 11.3~24.4 nm. The step bunching was almost constant at higher supersaturation. A few pits and holes appeared on the crystal surface at high supersaturation. In our opinion, the forming of these pits and holes might be related with the step movement and 2D nuclei mechanism.
In situ interference and AFM were used to study the effect of supersaturation and temperature on the growth rates and slopes of KDP crystal (101) faces.
1 February 2022 in Materials Chemistry and Physics