Haoyuan Gao

Mr. Haoyuan Gao

orcid

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
6 December 2022 in Buildings
Verified
Journal Article
Open access
PDF file
HGHaoyuan Gao
Haoyuan Gao
KZKun Zhang
Kun Zhang
XWXinyu WU
Xinyu WU
HLHongjiang Liu
Hongjiang Liu
LZLianzhen Zhang
Lianzhen Zhang
In this paper, the seismic response of a steel truss arch bridge subjected to near-fault ground motions is studied. Then, the idea of applying buckling restrained braces (BRBs) to a steel truss arch bridge in near-fault areas is proposed and validated. Firstly, the basic characteristics of near-fault ground motions are identified and distinguished. Furthermore, the seismic response of a long span steel truss arch bridge in the near fault area is analyzed by elastic-plastic time analysis. Finally, the braces prone to buckling failure are replaced by BRBs to reduce the seismic response of the arch rib through their energy dissipation properties. Four BRB schemes were proposed with different yield strengths, but the same initial stiffness. The basic period of the structure remains the same. The results show that near-fault ground motion will not only obviously increase the displacement and internal force response of the bridge, but also cause more braces to buckle. By replacing a portion of the normal bars with BRBs, the internal forces and displacements of the arch ribs can be reduced to some extent, which is more prominent under the action of pulsed ground motion. There is a clear correlation between the damping effect and the parameters of BRB, so an optimized solution should be obtained by comparison and calculation.

29 July 2025 in Engineering Structures
Verified
Journal Article
Closed access
XZXueqi Zhong
Xueqi Zhong
HGHaoyuan Gao
Haoyuan Gao
JLJianzhong Li
Jianzhong Li
Xu ChenXu Chen
Xu Chen

26 March 2025 in Engineering Structures
Verified
Journal Article
Closed access
HGHaoyuan Gao
Haoyuan Gao
JLJianzhong Li
Jianzhong Li
Xu ChenXu Chen
Xu Chen
ZGZhongguo Guan
Zhongguo Guan

9 March 2026 in Soil Dynamics and Earthquake Engineering
Verified
Journal Article
Closed access
HGHaoyuan Gao
Haoyuan Gao
JLJianzhong Li
Jianzhong Li
Xu ChenXu Chen
Xu Chen
XDXiaoqing Du
Xiaoqing Du
XZXueqi Zhong
Xueqi Zhong

17 June 2024 in Buildings
Verified
Journal Article
Open access
PDF file
ZBZe hua Bao
Ze hua Bao
WXWenjing Xu
Wenjing Xu
HGHaoyuan Gao
Haoyuan Gao
XZXueqi Zhong
Xueqi Zhong
JLJian zhong Li
Jian zhong Li
It is essential and convenient to use accurate and validated numerical models to simulate the seismic performance of post-tensioned (PT) rocking bridge piers, with a particular emphasis on accurately capturing rocking behavior. The primary contribution of this study is a comparison of the effectiveness of four commonly used numerical base rocking models (namely, the lumped plasticity (LP) model and the multi-contact spring (MCS) models with linear elastic (MCS-LE), bilinear elastic–plastic (MCS-EP) and nonlinear plastic (MCS-NP) material behavior, respectively) in modeling both the cyclic and seismic responses of PT rocking bridge piers. Also, this study validates the 3D contact stiffness equation for numerical models and assesses the differences between the dynamic and static stiffness values of the contact springs. Both quasi-static and shaking table tests of typical PT rocking piers are adopted to calibrate/validate these numerical models. These models describing the PT rocking piers’ seismic performance are formulated and calibrated, showing good agreement with test results for test specimens. Additionally, the suggested values of model spring stiffness for dynamic and quasi-static analyses are identified by parametric analysis. All base rocking models can predict the pier’s cyclic and seismic behavior after the calibration of contact spring stiffness values. The recommended contact stiffness for the dynamic analysis of PT rocking piers is smaller than that used for the quasi-static analysis. The results and findings provide a valuable reference and solution for the numerical simulation of PT rocking piers.

17 July 2024 in Applied Sciences
Verified
Journal Article
Open access
PDF file
HGHaoyuan Gao
Haoyuan Gao
LLLiuyang Li
Liuyang Li
ZDZhigang Ding
Zhigang Ding
LZLianzhen Zhang
Lianzhen Zhang
KZKun Zhang
Kun Zhang
ZLZhihao Luo
Zhihao Luo
During strong earthquakes, pounding may occur on large-span bridges and their approach bridges. The effect and mitigation measures of such pounding have rarely been explored in previous studies. This paper primarily uses finite element models to investigate the pounding effects at the expansion joints between the main cable-stayed bridge and its approach bridge. Friction pendulum bearings (FPBs) and fluid viscous dampers (FVDs) are used to alleviate poundings. Furthermore, a detailed analysis is conducted on how the pounding effect of the isolated main bridge with FPBs and FVDs is affected by the wave passage effect, ground motion type, and soil type. This study reveals that FPBs and FVDs can effectively reduce pounding effects and the associated risks. Even with the installation of FPBs and FVDs, lower seismic wave velocities and near-fault seismic motions with pulse effects can significantly increase the pounding effects between the cable-stayed bridge and its approach bridge.