When barriers are placed in parallel on opposite sides of a source, their performance deteriorates markedly. However, barriers made from materials of inhomogeneous impedance eliminate this drawback by altering the behavior of sound as it undergoes multiple reflections between the barriers. In this paper, a theoretical approach is carried out to estimate the performance of the proposed barriers. By combining the ray-tracing method and sound diffraction theory, the existence of different ray paths between the proposed barriers is revealed. Compared to conventional rigid-walled barriers, barriers having inhomogeneous surfaces may have the potential to be widely used in environmental noise control.
The screening effect of a roadside balcony deteriorates considerably due to sound reflection from its ceiling. Nonetheless, this drawback can be eliminated by artificially steering the reflected sound away from the building facade, which is achieved by introducing impedance inhomogeneity to the ceiling surface. This paper presents an elaborated investigation on the effect of the phase gradient of a ceiling surface on screening exterior noise, theoretically and numerically. By balancing its sound-steering capability and performance fluctuation level, such a balcony ceiling may have the potential to be widely used on roadside buildings.
1 July 2016 in The Journal of the Acoustical Society of America
In this paper, inhomogeneous boundaries having constant phase gradient are investigated. In principle, such a theoretically proposed boundary is dispersionless. In practice, however, when the boundary is realized by a subwavelength-structured tubes array, the impedance discretization brings about sub-reflections at high frequencies. Moreover, determined by the longest duct in the array, a realized boundary is impractically thick. Therefore, a finite-thickness boundary is further proposed by truncating and periodizing the tubes in the array. In this paper, the theoretical analysis agrees well with the numerical simulations. By appropriately choosing its phase gradient and target frequency, the finite-thickness boundaries have potential applications in noise control.
1 June 2017 in The Journal of the Acoustical Society of America
When sound barriers are installed on both sides of a noise source, degradation in performance is observed. Barriers having negative-phase-gradient surfaces successfully eliminate this drawback by trapping sound energy in between the barriers. In contrast, barriers can also be designed to “dredge” the energy flux out. An extended model considering higher-order diffractions, which resulted from the interplay of the induced surface wave and barrier surface periodicity, is presented. It is found that the sound dredging barriers provide a remarkable enhancement over the trapping ones, and hence have the potential to be widely used in noise control engineering.
Multiple valves in the pipeline system belong to obvious periodic structure distribution types. When a high-speed airstream flows through the pipeline valve, it produces obvious aero-acoustic and acoustic resonance. Acoustic resonant systems with single and six-pipe valves were investigated to understand the flow and acoustic characteristics using a numerical simulation method and testing method. The strongest acoustic resonance occurred at a specific flow velocity with a corresponding Strouhal number of 0.47 corresponding to the geometric parameters in the paper. Moreover, acoustic resonance occurred in a certain velocity range, rather than increasing with the increase of the velocity of the pipeline. This regular increase provided an important theoretical basis for the prediction of the acoustic resonant and ultimate acoustic load of a single-valve system. When the pipeline was attached with multiple valves and the physical dimension was large, the conventional aero-acoustics calculation results were seriously attenuated at high frequency; the calculation method involving a cut-off frequency in this paper was presented and could be used to explain the excellent agreement of the sound pressure level (SPL) below the cut-off frequency and the poor agreement above the cut-off frequency. A new method involving steady flow and stochastic noise generation and radiation (SNGR) was proposed to obtain better results for the SPL at the middle and high frequencies. The comparison results indicated that the traditional method of Lighthill analogy and unsteady flow could accurately acquire aerodynamic noise below the cut-off frequency, while the new method involving steady flow and SNGR could quickly acquire aerodynamic noise above the cut-off frequency.