The rural villages situated in the east coast zone of India are facing acute shortage of electrical power which considerably affects the overall development of the region. Major sources of energy poverty in this locality are from low voltage and intermittent power supply from the existing utility systems. Mismatch between the demand and supply for the long transmission and distribution systems is the major cause of such situations. In this paper, an attempt has been made to solve this long standing problem economically, using a feasible energy co-operative based wind-solar hybrid generation system. This generated power will be distributed among co-operative registered designated loads through a standalone hybrid micro-grid system within the scope of the regulations in the national deregulated electricity market. Besides, both technical and non-technical power losses associated with the existing utility systems can be significantly curbed through the proposed energy co-operative scheme. The scheme has been satisfactorily implemented using MATLAB Simulink and HOMER Pro-3.2 simulation tool and validated through a prototype experimental setup. The laboratory testing is carried out through a 10kW generation and utilization system, which can be customized further for the wide-area rural power supply.
1 May 2016 in International Journal of Electrical Power & Energy Systems
A wind–solar hybrid system using doubly fed induction generator (DFIG) is described in this study. An optimum rotor current control strategy considering minimum losses of the induction generator over entire period of operation is proposed. In the proposed scheme, a solar photovoltaic (PV) unit of appropriate capacity has been augmented with the rotor circuit of the DFIG along with a marginal battery backup to supplement the rotor power in order to maintain continuity of power generation. The active power fluctuations at the stator terminals of the DFIG can be minimised as both solar PV and wind energy can complement each other during lean periods of either of the sources. The proposed scheme has been simulated and experimentally validated with a 2.5 kW DFIG using dSPACE CP1104 module, which produced satisfactory results.
9 January 2018 in International Transactions on Electrical Energy Systems
A novel wind energy conversion system (WECS) with cogeneration topology is presented in this study. In the proposed scheme, doubly‐fed induction generator (DFIG) is used as the major source for power generation in grid‐isolated mode. The wind turbine operated DFIG is integrated with a permanent magnet ac generator and a solar photovoltaic (PV) module to supplement the both rotor power requirement of DFIG and part of the average load power demand. The performance of a grid‐isolated WECS, over wide speed range can be significantly improved through the sequential extraction of wind power along with an augmented solar PV source. The proposed scheme is economically viable with feasible unit cost of generated power. The control scheme has been simulated and experimentally validated with a practical 2.5 kW DFIG using dSPACE DS1104 module, which produced satisfactory results.