The method presented in this paper assumes that the received signal is a linear combination of delayed and attenuated uncorrelated replicas of the source emitted waveform. The set of delays and attenuations, together with the channel environmental conditions, provide sufficient information for determining the source location. If the transmission channel is assumed known, the source location can be estimated by matching the data with the acoustic field predicted by the model conditioned on the estimated delay set. This paper presents alternative techniques that do not directly attempt to estimate time delays from the data but, instead, estimate the subspace spanned by the delayed source signal paths. Source Localization is then done using a family of measures of the distance between that subspace and the subspace spanned by the replicas provided by the model. Results obtained on the INTIMATE'96 data set, in a shallow-water acoustic channel off the coast of Portugal, show that a sound source emitting a 300-800-Hz LFM sweep could effectively be localized in range or depth over an entire day.
6 September 2013 in IEEE Journal of Oceanic Engineering
Underwater acoustic networks (UANs) are an emerging technology for a number of oceanic applications, ranging from oceanographic data collection to surveillance applications. However, their reliable usage in the field is still an open research problem, due to the challenges posed by the oceanic environment. The UAN project, a European-Union-funded initiative, moved along these lines, and it was one of the first cases of successful deployment of a mobile underwater sensor network integrated within a wide-area network, which included above water and underwater sensors. This contribution, together with a description of the underwater network, aims at evaluating the communication performance, and correlating the variation of the acoustic channel to the behavior of the entire network stack. Results are given based on the data collected during the UAN11 (May 2011, Trondheim Fjord area, Norway) sea trial. During the experimental activities, the network was in operation for five continuous days and was composed of up to four Fixed NOdes (FNOs), two autonomous underwater vehicles (AUVs), and one mobile node mounted on the supporting research vessel. Results from the experimentation at sea are reported in terms of channel impulse response (CIR) and signal-to-interference-plus-noise ratio (SINR) as measured by the acoustic modems during the sea tests. The performance of the upper network levels is measured in terms of round trip time (RTT) and probability of packet loss (PL). The analysis shows how the communication performance was dominated by variations in signal-to-noise ratio, and how this impacted the behavior of the whole network. Qualitative explanation of communication performance variations can be accounted, at least in the UAN11 experiment, by standard computation of the CIR and transmission loss estimate.
1 May 2003 in The Journal of the Acoustical Society of America
Matched-field based methods always involve the comparison of the output of a physical model and the actual data. The method of comparison and the nature of the data varies according to the problem at hand, but the result becomes always largely conditioned by the accurateness of the physical model and the amount of data available. The usage of broadband methods has become a widely used approach to increase the amount of data and to stabilize the estimation process. Due to the difficulties to accurately predict the phase of the acoustic field the problem whether the information should be coherently or incoherently combined across frequency has been an open debate in the last years. This paper provides a data consistent model for the observed signal, formed by a deterministic channel structure multiplied by a perturbation random factor plus noise. The cross-frequency channel structure and the decorrelation of the perturbation random factor are shown to be the main causes of processor performance degradation. Different Bartlett processors, such as the incoherent processor [Baggeroer et al., J. Acoust. Soc. Am. 80, 571–587 (1988)], the coherent normalized processor [Z.-H. Michalopoulou, IEEE J. Ocean Eng. 21, 384–392 (1996)] and the matched-phase processor [Orris et al., J. Acoust. Soc. Am. 107, 2563–2375 (2000)], are reviewed and compared to the proposed cross-frequency incoherent processor. It is analytically shown that the proposed processor has the same performance as the matched-phase processor at the maximum of the ambiguity surface, without the need for estimating the phase terms and thus having an extremely low computational cost.
1 November 2010 in The Journal of the Acoustical Society of America
This paper proposes a vector sensor measurement model and the related Bartlett estimator based on particle velocity measurements for generic parameter estimation, illustrating the advantages of the Vector Sensor Array (VSA). A reliable estimate of the seabed properties such as sediment compressional speed, density and compressional attenuation based on matched-field inversion (MFI) techniques can be achieved using a small aperture VSA. It is shown that VSAs improve the resolution of seabed parameter estimation when compared with pressure sensor arrays with the same number of sensors. The data considered herein was acquired by a four-element VSA in the 8–14 kHz band, during the Makai Experiment in 2005. The results obtained with the MFI technique are compared with those obtained with a method proposed by C. Harrison, which determines the bottom reflection loss as the ratio between the upward and downward beam responses. The results show a good agreement and are in line with the historical information for the area. The particle velocity information provided by the VSA increases significantly the resolution of seabed parameter estimation and in some cases reliable results are obtained using only the vertical component of the particle velocity.
1 August 2008 in The Journal of the Acoustical Society of America
Passive time reversal has aroused considerable interest in underwater communications as a computationally inexpensive means of mitigating the intersymbol interference introduced by the channel using a receiver array. In this paper the basic technique is extended by adaptively weighting sensor contributions to partially compensate for degraded focusing due to mismatch between the assumed and actual medium impulse responses. Two algorithms are proposed, one of which restores constructive interference between sensors, and the other one minimizes the output residual as in widely used equalization schemes. These are compared with plain time reversal and variants that employ postequalization and channel tracking. They are shown to improve the residual error and temporal stability of basic time reversal with very little added complexity. Results are presented for data collected in a passive time-reversal experiment that was conducted during the MREA’04 sea trial. In that experiment a single acoustic projector generated a 2∕4-PSK (phase-shift keyed) stream at 200∕400 baud, modulated at 3.6kHz, and received at a range of about 2km on a sparse vertical array with eight hydrophones. The data were found to exhibit significant Doppler scaling, and a resampling-based preprocessing method is also proposed here to compensate for that scaling.