The BeiDou Global Navigation Satellite System (BDS-3) can provide PPP-B2b satellite-based Precise Point Positioning (PPP) real-time service to the Asia–Pacific region via PPP-B2b signal transmitted from the three Geostationary Earth Orbit (GEO) satellites. This paper provides a comprehensive evaluation of the accuracies of the satellite’s precise real-time orbit and clock products, including BDS-3 PPP-B2b precise products and the precise real-time products provided by four IGS centers (CAS, DLR, GFZ, and WHU). In addition, the influences of these real-time precise satellite products on the PPP positioning accuracy with single-frequency and dual-frequencies are also studied. Furthermore, the accuracies of broadcast ephemeris and IGS ultra-rapid products are studied, as well as their impact on PPP accuracies. Results illustrate that the orbits accuracies of PPP-B2b orbits are 9.42 cm, 21.26 cm, and 28.65 cm in the radial, along-track, and cross-track components, which are slightly lower than those of real-time orbits provided by the four IGS centers. However, the accuracy of PPP-B2b clock biases is 0.18 ns, which is higher than those provided by IGS Real-Time Service (RTS). In the static positioning test, the 3D positioning accuracy of B1I+B3I dual-frequencies PPP and B1C single-frequency PPP are centimeter-level while using PPP-B2b service, which is slightly lower in horizontal components compared to those obtained based on IGS RTS products. The results of the dynamic vehicle test indicate that the positioning accuracies of B1I+B2b dual-frequency PPP are about 50 cm and 120 cm in horizontal and vertical components, which are close to those of B2b single-frequency PPP using PPP-B2b service. Generally, the PPP-B2b orbit and clock accuracies on real-time PPP present similar performance to that based on IGS RTS.

Due to the virtues of low-cost and high positioning accuracy, Single-Frequency Precise Point Positioning (SF-PPP) is becoming a prospective technique. However, SF-PPP is not as widely used as dual-frequency and triple-frequency PPP at present, owing to the effect of ionospheric delay residuals after model rectification. In recent years, with the evolution of multi-constellation Global Navigation Satellite Systems (multi-GNSS, i.e., GPS, BDS-2, and BDS-3), it has become possible to obtain credible and continuous positioning results using SF-PPP. However, such performance would be significantly degraded in challenging environments (i.e., boulevards, tunnels, and tall buildings). Under these circumstances, GNSS signals are obstructed, and it is difficult to provide sufficient observations for SF-PPP. Therefore, the Inertial Navigation System (INS) is employed to promote the positioning performance of SF-PPP. The PPP/INS integration is regarded as one of the most efficient approaches in GNSS-denied environments. To satisfy the request of supplying real-time positioning information, the Real-Time Services (RTS) of the International GNSS Service (IGS) provide real-time precise orbit and clock products for globally distributed users through the internet. In this paper, a real-time GPS/BDS-2/BDS-3 SF-PPP and INS tight integration model is proposed, and it is assessed using the data gathered by vehicle and real-time products afforded by CAS (Chinese Academy of Sciences), GFZ (Deutsche GeoForschungsZentrum), and WHU (Wuhan University). The outcomes illustrate the following: (1) GPS + BDS SF-PPP/INS can provide more accurate and continuous positioning solutions compared with those of GPS + BDS SF-PPP, with improvements of 52.8%, 31.1%, and 42.8% in the north, east, and vertical components, respectively. (2) In general, the orbit and clock products’ accuracies in terms of GPS afforded by the three analysis centers are consistent with each other. For BDS, the orbit product from WHU is more accurate compared to those of CAS and GFZ. However, the accuracy of the clock product afforded by WHU is lower compared with those provided by the other two centers, especially for BDS-2 satellites. (3) The positioning accuracy in terms of Root Mean Square (RMS) values based on GFZ products are much higher than the results based on CAS and WHU products in the three directions.

Owing to the developments of satellite-based and network-based real-time satellite precise products, the Precise Point Positioning (PPP) technique has been applied far and wide, especially since the PPP-B2b service was provided by the third-generation BeiDou Navigation Satellite System (BDS-3). However, satellite outages during dynamic application lead to significant degradation of the accuracy and continuity of PPP. A generally used method is integrating PPP with Inertial Measurement Units (IMUs) to enhance positioning performance. Previous works on this topic are usually based on IMU data at a high sampling rate and are mostly implemented in post-processing mode. This paper will carry out a compressive assessment of the impacts of different types of precise satellite products (real-time products from the CAS, DLR, GFZ, WHU, and the final one from GFZ), Doppler observations, and different sampling rates of IMU data on the performance of the tightly coupled integration of the BDS-3 B1I/B2b and the Inertial Navigation System (INS). Results based on a group of on-board experimental data illustrate that (1) the positioning accuracy with products supplied by the CAS and WHU are roughly consistent with those using the final products; (2) the Doppler observations can effectively improve the accuracies of velocity, attitude, and vertical position at the initial epochs and during the reconvergence periods, but have invisible influences on the overall positioning, velocity, and attitude determination; and (3) the impact of IMU data interval on the performance of PPP/INS tightly coupled integration is insignificant when there are enough available satellites. However, the divergent speed of position is visibly affected by the IMU sampling rate during satellite outage periods.