We design and fabricate a low-loss silicon photonic two-dimensional grating coupler that serves to couple light between standard single-mode fibers and single-mode waveguides in the silicon-on-insulator platform and to split both orthogonal polarization states. The efficiency of the fabricated device is enhanced by a backside metal mirror and reaches a record value of with a 1 dB bandwidth of 32 nm around 1550 nm. The demonstrated coupling efficiency is 2.2 dB better than the conventional two-dimensional grating coupler without a metal mirror.
21 July 2020 in IEEE Transactions on Electron Devices
Green resonant-cavity light-emitting diode (RCLED) has great potential in optical communication but suffers low efficiency. In this study, GaN-based flip-chip green RCLED incorporated with nitrogen face-oriented inclination asymmetric trapezoidal quantum wells (NOAT-QWs) is proposed to enhance the light-output power (LOP). Samples with NOAT-QWs and normal symmetric square quantum wells (SS-QWs) were fabricated and characterized. Although their electrical characteristics and emission spectra are similar, the LOP and emission efficiency are significantly improved. At a driving current of 450 mA, the improvement of LOP for RCLED with NOAT-QWs can be as high as 1.44 times in comparison to the sample with SS-QWs. The unprecedented high output power of 115 ,mW ,and the narrow full-width-at-half-maximum ,(FWHM) of 6.4 nm in the emission spectrum give great potential in optical communication. The inherent mechanism was investigated by the finite element analysis, from which the simulation results match well with the experimental measurements. The simulation ,results reveal that the ,NOAT-QWs are beneficial in alleviating the quantum confined stark effect and facilitating easier hole carriers' flow across the barriers, leading to more electron-hole wave function overlaps and higher radiative recombination rate.
To optimize the uniformity of signal-to-noise ratio (SNR) distribution in a visible light communication (VLC) system, the firefly algorithm is improved for joint optimization of location, power allocation and orientation of a light-emitting diode (LED) lamp array. Taking 16 LED lamps as an example, optimizations with a different number of degrees-of-freedom (DOF) are investigated. The orientation-involved optimizations significantly decrease average SNR and average illuminance. However, if the average illuminance is restricted to a large value, the effects of the orientation DOF would be small. With the restriction of illuminance, the optimization with all the three DOFs gives an improvement of 4.18 times in SNR uniformity, compared to the typical square-circle layout. The optimizations are further studied by varying the number of LED lamps.
The quantum dot (QD) light-emitting diode (LED) is a robust scheme for single photon source. However, the spontaneous emission of a QD LED has arbitrary directions and polarizations, which is disadvantage for photon collection and manipulation. We propose a QD LED integrated with an Ag grating and a phase-gradient metasurface. The circular patterned Ag grating is adopted to collimate the emission beam with right phase and improve its spatial coherence, therefore a phase-gradient metasurface can work for beam manipulation. The 10°, 20°, and 30° angle deflection as well as doughnut-pattern generation are demonstrated by numerical simulation. A small metasurface with the width of 6 µm can provide a collection efficiency of 25.9% at the deflection angle of 10°. Furthermore, only one single QD can be selected from a QD assembly with a low-density.