Ruthenium is required to separate from high-level liquid waste (HLLW) because Ru is a valuable resource and is negatively influential on the vitrification process of HLLW. However, the separation of Ru is very challenging due to its complicated complexation properties. In this study, the adsorption and desorption characteristics of ruthenium on a synthesized SiPyR-N3 (weak-base anion exchange resin with pyridine functional groups) composite were investigated in nitric acid and nitrite–nitric acid systems, respectively, and the adsorption mechanism was explored. The experimental results showed that SiPyR-N3 has a significantly better adsorption effect on Ru in the nitrite–nitric acid system than in the nitric acid system, with an increase in the adsorption capacity of approximately three times. The maximum adsorption capacity of Ru is 45.6 mg/g in the nitrite–nitric acid system. The SiPyR-N3 possesses good adsorption selectivity (SFRu/other metal ions is around 100) in 0.1 M NO2−–0.1 M HNO3 solution. The adsorption processes of Ru in the two different systems are fitted with the pseudo-second-order kinetic model and Langmuir model for uptake kinetics and adsorption isotherms, respectively. The results obtained from the FT-IR, XPS, and UV absorption spectrometry indicate that NO2− was involved in the adsorption process either as a complexing species with the metal ions or as free NO2− from the solution. A 0.1 M HNO3 + 1 M thiourea mixed solution shows effective desorption performance, and the desorption efficiency can reach 92% at 328 K.
1 February 2025 in Journal of the Electrochemical Society
Molten salt electrolysis represents an economical technique for the extraction and purification of metals while also enabling the reprocessing of spent fuel. The kinetic parameters of the electrolytic refining process are intricate and significant influence the separation of lanthanides and actinides. Here we report an investigation of the kinetics of the reduction process of Yb(III) on a cathodic Zn electrode and the influencing factors that impact the efficiency of electrolytic extraction in LiCl-KCl molten salt. The exchange current densities of Yb(II)/Ybin Zn couple on the liquid Zn electrode was measured by polarization curves, and the activation energy was calculated 18.02 kJ mol−1. Moreover, Yb was extracted on the Zn electrode from molten salt by potentiostatic electrolysis and galvanostatic electrolysis. The concentration of Yb(III) in the molten salt was measured using ICP-OES every 2 h, and the extraction efficiency and average extraction rate were calculated. The electrolysis condition with the highest extraction efficiency (98.39%) was by GE at 47.24 mA cm−2 when the electrolysis time was 10 h. The products of extraction were characterized by X-ray diffraction and scanning electron microscopy energy-dispersive spectroscopy to analyze the phase composition and microstructure of the alloy.