In this paper, the effect of water, air, and their combined injection from two different injection points is studied in order to reduce vorticity effects in a draft tube of prototype turbine working at three operating points. The flow from spiral case to the end of draft tube is simulated using the shear stress transport k–ω turbulence and two-phase models. Using an appropriate validation method, acceptable results were obtained under the noninjection condition. To determine suitable number of points and inlet flow rate for air injection as well as the appropriate nozzle diameter for air and water injection, a new method which considers the ratio of total loss to the pressure recovery factor is used, in addition to using the traditional method which calculates the total loss in the draft tube. Comparing results of the three types of injections shows air injection in the operating range greater than 70% of turbine design flow rate, is much more effective than water injection or the combination of air and water injection. However, in the operating range below 70%, either water or air injections are not suitable, but combination of these two fluids can improve system performance.
1 January 2015 in Journal of Clean Energy Technologies
Non-Newtonian fluids have not been frequently considered in different research although they are common fluid type in the industry and environment in comparison to Newtonian fluids. In this paper, a non-Newtonian fluid with a shear-thinning property is considered in a specific geometric condition. The flow is considered to be laminar, and the geometric subject of the research is a rectangular duct with an obstacle, which is assumed to be in the middle of the duct with a height of half the duct width. This research provides a numerical solution using a written MATLAB code with a SIMPLEC algorithm and a power law model. This code is validated by comparing code results with analytical results for a specific condition. The results of this research show variations of velocity and viscosity in the duct, which can be extremely useful in future research and applications, not only because of frequent usage of shear-thinning fluids in industrial applications but also because of the common duct shape facilities in different processes in several industries.
Hydropower plant vibrations due to pressure fluctuations and their troubleshooting methods are some of the most challenging issues in power plant operation and maintenance. This paper targets these fluctuations in a prototype turbine in two geometries: the initially approved design and the as-built design. Due to topographic conditions downstream, these geometries slightly differ in the draft tube height; the potential effect of such a slight geometrical change on the applicability of troubleshooting techniques is investigated. Therefore, the water flow was simulated using the CFD scheme at three operating points based on the SST k–ω turbulence model, while the injection of water/air was examined to decrease the pressure fluctuations in the draft tube, and the outputs were compared with no-injection simulations. The results show that a slight change in draft tube geometry causes the pressure fluctuations to increase 1.2 to 2.8 times after 4 s injecting at different operating points. The modification in the location of the air injection also could not reduce the increase in pressure fluctuations and caused a 3.6-fold increase in pressure fluctuations. Therefore, the results show that despite water/air injection being a common technique in the hydropower industry to reduce pressure fluctuations, it is effective only in the initially approved design geometry. At the same time, it has a reverse effect on the as-built geometry and increases the pressure fluctuations. This research highlights the importance of binding the construction phase with the design and troubleshooting stages and how slight changes in construction can affect operational issues.
1 January 2015 in Journal of Clean Energy Technologies