With the continuous promotion of urbanization, the generation of construction and demolition waste (CDW) is increasing. The environmental problems and safety hazards caused as a result need to be resolved. In this paper, based on the system dynamics (SD) theory, the modeling, the cost, and the environmental benefit of CDW resource management under the life cycle assessment (LCA) are proposed. Specifically, we propose a combined policy derived through three variables, namely, fines, subsidies, and charges. The target is to reduce illegal dumping behavior and landfill volume and to improve the recycling volume and environmental benefits. The model is constructed with the help of the software VENSIM, and the validity and feasibility of the model are demonstrated with data from Nantong City. The results show that a single policy cannot simultaneously improve environmental benefits, illegal dumping, recycling, and landfill behavior. A combined policy combines the advantages of three single policies, fines, subsidies, and charges, which not only can effectively curb illegal dumping and landfill disposal under the premise of prioritizing environmental benefits, but can also promote the recycling of CDW. The reasonable range for the fine is 300–350 CNY/ton; the rational range for subsidies is 30–40 CNY/ton; and the flexible range for treatment charge is 40–80 CNY/ton. The model can be used for the quantitative assessment of urban CDW management costs and environmental benefits and can also provide a theoretical basis for the government.

Phosphors-in-glass (PiGs) regarded as a promising phosphor-converter for white light emitting diodes (WLEDs) is being researched widely. However, there are few reports on the effect of changing the shape of PiGs on the color rendering index (CRI) and heat dissipation of WLEDs. In this paper, gel casting with Isobam was first attempted in preparing special-shaped PiGs successfully. It exhibited that 76 wt.% was the optimum solid content based on the rheological properties of slurry and the shrinkage of green bodies. The sintering rate should be kept at a low speed and glass transition temperature (Tg) of glass powders must be higher than sublimation temperatures (Ts) of APS and Isobam. The CRI of PiGs was increased by about 27% after changing the shape of PiGs from cylinder to dome. Most importantly, operating temperature also reduced effectively the increase of the surface area of PiGs. Therefore, changing the shape of PiGs by gel casting with Isobam is a creative way for high-power WLEDs lighting.