Extensively used in modern gas turbine engines in various applications, ranging from aerospace, marine and terrestrial propulsion to power generation and gas pumping, the axial flow turbines have been continuously updated and are now capable of high performances and reliability. One drawback that has not yet been resolved is the poor performance of the axial turbines at lower- than-nominal regimes. To solve these shortcomings, a new method to improve the performances at partial regimes by specific fluid injection is proposed in this paper. The influence of the injection system is determined by conducting a numerical analyze, studying the influence of different parameters (i.e., number, dimensions and position of the of injection orifices) on the overall performances of the turbine. The study is completed on a single stage 1300 KW turbine with the injection system being applied to different power settings across the working line. The results show that the power generated by the turbine can be enhanced by as much as 30% for different configurations of the injection system (i.e., high number of small size orifices) and different partial regimes.

As a main component of most gas-turbine engines, the axial flow turbines have been in a process of continuous improvement, reaching high efficiencies and reliability. A well-known drawback of these systems is the rapid decrease in performance when operating at lower than nominal conditions. Thus, a novel performance-enhancement method for axial turbines operating at partial loads has been previously proposed and numerically characterized. In this paper, one applies the aforementioned method for a smaller size axial flow turbine, part of a gas-generator assembly for a microjet engine, to determine, by the use of CFD analysis, the influence of the system at different partial regimes across the working line. A logical scheme based on iterative steps and multiple numerical simulations is also used to determine the engine response to the injection of compressor bleed air into the turbine passages. The results show, as determined in the previous study, that the generated power can be increased for all partial regimes, with the influence being more noticeable at higher regimes, leading to a reduction in fuel consumption in order to achieve the same regimes.

Gas turbine engines are an essential component for many industries, such as aerospace, marine propulsion, energy generation, etc., with modern engines capable of achieving high powers, efficiencies and reliability. However, these high performances are achieved on a narrow interval of working regimes; when operating at partial loads, a drastic decrease in performance is expected. In order to mitigate this drawback, a novel injection method has been proposed to improve axial turbine and gas turbine engine performance at these regimes. The method consists of the injection of a fluid in specific sections of turbine vanes to accelerate the flow, modify the velocity triangles and increase the generated power at partial loads. In this paper, the authors discuss the internal flow characteristics of the injection channels using numerical studies to determine the flow fields for different working regimes. The results show that the power generated by the rotor can be improved by 10% to 21% for different operating regimes without considering the internal geometries. The introduction of internal flow configurations led to smaller improvements in power generation, obtaining injection system pressure losses of between 10% and 20%. The paper concludes that the flow through channels is not uniform, with smaller dimensions of the internal geometries leading to higher pressures and an increased influence of the injection system.