The electronic structure of showing a metal-insulator transition and a sequence of different charge density wave (CDW) transformations was discussed in the frame of variable temperature angle-resolved photoelectron spectroscopy (ARPES), scanning tunneling spectroscopy (STS), and density functional theory (DFT) calculations. For the commensurate charge density wave phase (CCDW) the Mott gap was estimated to be 0.4 eV and energy gaps were observed. For the nearly commensurate charge density wave phase (NCCDW), the reminiscent of higher and lower Hubbard bands and a very pronounced electronic state associated with the parabolic band at the point in the Brillouin zone were identified. The incommensurate charge density wave phase (ICCDW) showed a high value of local density of states at the Fermi level and a very pronounced edge of the metallic surface state located in the range of 0.15–0.20 eV above the Fermi level. The obtained STS and ARPES results were consistent with our theoretical calculations performed within DFT formalism including spin-orbit coupling.
17 August 2022 in ACS Applied Materials & Interfaces
We propose that the crystallinity of two-dimensional (2D) materials is a crucial factor for achieving highly effective work function (WF) modification. A crystalline 2D MoO3 monolayer enhances substrate WF up to 6.4 eV for thicknesses as low as 0.7 nm. Such a high WF makes 2D MoO3 a great candidate for tuning properties of anode materials and for the future design of organic electronic devices, where accurate evaluation of the WF is crucial. We provide a detailed investigation of WF of 2D α-MoO3 directly grown on highly ordered pyrolytic graphite, by means of Kelvin probe force microscopy (KPFM) and ultraviolet photoemission spectroscopy (UPS). This study underlines the importance of a controlled environment and the resulting crystallinity to achieve high WF in MoO3. UPS is proved to be suitable for determining higher WF attributed to 2D islands on a substrate with lower WF, yet only in particular cases of sufficient coverage. KPFM remains a method of choice for nanoscale investigations, especially when conducted under ultrahigh vacuum conditions. Our experimental results are supported by density functional theory calculations of electrostatic potential, which indicate that oxygen vacancies result in anisotropy of WF at the sides of the MoO3 monolayer. These novel insights into the electronic properties of 2D-MoO3 are promising for the design of electronic devices with high WF monolayer films, preserving the transparency and flexibility of the systems.
15 August 2017 in The Journal of Physical Chemistry C
We report on van der Waals epitaxy of two-dimensional (2D) molybdenum trioxide (MoO3−x) with monolayer thickness directly grown on highly oriented pyrolytic graphite by thermal evaporation under ultrahigh vacuum. The chemical composition, electronic and crystalline lattice structures of the mono-and few-layer MoO3−x sheets are analysed. Using scanning tunnelling microscopy and spectroscopy, we investigate the electronic properties of MoO3−x as a function of the number of layers and measure the apparent energy gap to be 0.4 eV for the first three layers of MoO3−x on graphite. We carried out density functional theory calculations to shed light on the mechanism underlying the observed narrow bandgap with oxygen deficiency. Moreover, the air exposure effect on monolayer MoO3−x is investigated confirming that the apparent bandgap closes, and additionally we show the reduction of the work function from 5.7 to 4.7 eV. We prove that it is possible to synthesize the 2D, non-stoichiometric, and electrically conductive MoO3−x.
25 August 2015 in The Journal of Physical Chemistry C