Lithium metal batteries (LMBs) are a key product for sustainable and efficient electric transport. Long-life and safe LMBs require the development of solid or semisolid (e.g., gel polymer) electrolytes capable of blocking lithium dendrites. In this context, Janus double-faced membranes (JMs) offer interesting perspectives, as they allow for modulating the properties of each side according to specific requests. In this paper, we report on facile fabrication via the solvent casting of JMs based on poly(vinylidene fluoride hexafluoropropylene) (PVDF-HFP). Here, an electronically insulating layer containing Al₂O₃ is in contact with the anode, whereas a mixed ionically–electronically conducting layer containing Al₂O₃, carbon nanotubes, and Super P carbon black is in contact with the cathode. We also investigate the role of the JM thickness and show that a 40 μm membrane allows for ~45% of the specific nominal capacity at 2C with Coulombic efficiency of ~100%. The proposed JMs are very promising for LMBs.

Dielectric elastomer generators (DEGs) are electrostatic transducers capable of harvesting electrical energy from oscillating mechanical parts and storing it in a battery or supercapacitor. The energy conversion element typically consists of a flexible capacitor with a variable capacitance that depends on the applied stress cycle and requires an external voltage source (bias voltage). In designing an energy harvesting device from human gait, we propose integrating two components: a dielectric elastomer fabricated using a nanocomposite polyurethane (TPU-CaCu₃Ti₄O₁₂) and an electret serving as a bias voltage source. In this work, we report on the electret fabrication and long-term charge retention properties using corona charging. The manufactured electrets are tested in coupling with the dielectric elastomer and allowed us to harvest an energy amount of 62 µJ/cycle (3.1 µJ/cm²) on a resistive load of 450 MΩ during motion cycles at a frequency of 0.5 Hz. Given the materials used, this approach is well suited to harvesting energy from human gait and holds promise for powering wearable devices.

An experimental method exploiting the capacitive response of most materials is here revised. The procedure called the “Voltage Ramp Method” (VRM) is based on applying proper voltage ramp cycles over time and measuring electrical current intensity flowing through the material sample. In the case of an ideal capacitor, a current plateau should be easily measured, and the capacitance value precisely determined. However, most media, e.g., semiconductors and insulating polymers, show dielectric absorption and hence electric leakage effects. Therefore, the VRM method allows simultaneous determination of their equivalent capacitance and resistance. Some case studies are discussed as concerning the application of VRM to both standard and actual media. A figure of merit of the method is the percentage difference between 2.5% and 1.5% with respect to the nominal values of a commercial capacitor and resistor, respectively. The simulation modeling of the material electrical response is compared to the experimental data also on polymer nanocomposites suitable for energy harvesting.