Slobodanka Galovic

Prof. Dr. Slobodanka Galovic

Institute of Nuclear Sciences, Vinča, Belgrade, Serbia
orcid

Research Focus & Metrics

Academic Career Length

29Years (1998-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 March 2003 in Journal of Applied Physics
Verified
Journal Article
Closed access
PDF file
Slobodanka GalovicSlobodanka Galovic
Slobodanka Galovic
DKD. Kostoski
D. Kostoski
Generalized expressions of photothermal wave propagation are derived, including the thermal memory effects. The focus is on optically opaque solids. The models of photothermal spectra based on the suggested descriptions are discussed for a semi-infinite sample and two limiting cases of backing—an ideal insulator and an ideal conductor backing. The results are compared with previous models.

1 February 2005 in Polymer Degradation and Stability
Verified
Journal Article
Closed access
ZSZ. Stojanović
Z. Stojanović
ZKZorica Kacarevic-Popovic
Zorica Kacarevic-Popovic
Slobodanka GalovicSlobodanka Galovic
Slobodanka Galovic
DMDejan Milicevic
Dejan Milicevic
Edin SuljovrujicEdin Suljovrujic
Edin Suljovrujic

1 August 2007 in Radiation Physics and Chemistry
Verified
Journal Article
Closed access
DMDejan Milicevic
Dejan Milicevic
STS. Trifunovic
S. Trifunovic
Slobodanka GalovicSlobodanka Galovic
Slobodanka Galovic
Edin SuljovrujicEdin Suljovrujic
Edin Suljovrujic

8 July 2014 in Journal of Applied Physics
Verified
Journal Article
Closed access
PDF file
Slobodanka GalovicSlobodanka Galovic
Slobodanka Galovic
ZŠZlatan Šoškić
Zlatan Šoškić
MPM. Popović
M. Popović
Dalibor ChevizovichDalibor Chevizovich
Dalibor Chevizovich
ZSZ. Stojanović
Z. Stojanović
This paper presents a model for indirect photoacoustic response that includes thermal memory effects. At low frequencies, the model reduces to the well-known thermal piston model of photoacoustic response given by Rosencweig and Gersho. However, at high frequencies, the presented model predicts resonant behavior of amplitudes and phases of photoacoustic response and determines the respective resonant frequencies. The results of the presented model enable experimental determination of standard thermal properties of solids (thermal diffusivity and thermal conductivity), as well as thermal memory properties, thermal relaxation time, and heat propagation speed.

25 June 2015 in Journal of Applied Physics
Verified
Journal Article
Closed access
PDF file
DMD. D. Markushev
D. D. Markushev
Jose  Ordonez-MirandaJose Ordonez-Miranda
Jose Ordonez-Miranda
MRMihailo Rabasovic
Mihailo Rabasovic
Slobodanka GalovicSlobodanka Galovic
Slobodanka Galovic
DTD. M. Todorović
D. M. Todorović
SBS. E. Bialkowski
S. E. Bialkowski
The open-cell photoacoustic signal measured in the transmission configuration for aluminum thin plates with thicknesses of 280 μm, 197 μm, and 112 μm is experimentally and theoretically analyzed, in the 20 Hz–7 kHz modulation frequency range. It is shown that the observed differences between the predictions of the standard thermoelastic model and the experiment data of both the amplitude and phase of the photoacoustic signal can be overcome by considering the aluminum samples coated with a thin layer of black paint as volume-absorber materials. This new approach provides a quite good agreement with the obtained experimental data, in the whole frequency range, and yields an effective absorption coefficient of (16 ± 2) mm−1, for a 280 μm-thick sample. The introduction of the finite absorption coefficient led to the correct ratio between the thermal diffusion and thermoelastic components of the photoacoustic signal. Furthermore, it is found that the “volume-absorber” approach accurately describes the behavior of the amplitude, but not that of the phase recorded for a 112 μm-thick sample, due to its relatively strong thermoelastic bending, which is not considered by this theory. Within the approximation of the small bending, the proposed “volume-absorber” model provides a reliable description of the photoacoustic signal for Al samples thicker than 112 μm, and extends the applicability of the classical “opaque” approach.

1 March 2015 in Review of Scientific Instruments
Verified
Journal Article
Closed access
PDF file
DMD. D. Markushev
D. D. Markushev
MRMihailo Rabasovic
Mihailo Rabasovic
DTD. M. Todorović
D. M. Todorović
Slobodanka GalovicSlobodanka Galovic
Slobodanka Galovic
SBS. E. Bialkowski
S. E. Bialkowski
Methods for photoacoustic signal measurement, rectification, and analysis for 85 μm thin Si samples in the 20-20 000 Hz modulation frequency range are presented. Methods for frequency-dependent amplitude and phase signal rectification in the presence of coherent and incoherent noise as well as distortion due to microphone characteristics are presented. Signal correction is accomplished using inverse system response functions deduced by comparing real to ideal signals for a sample with well-known bulk parameters and dimensions. The system response is a piece-wise construction, each component being due to a particular effect of the measurement system. Heat transfer and elastic effects are modeled using standard Rosencweig-Gersho and elastic-bending theories. Thermal diffusion, thermoelastic, and plasmaelastic signal components are calculated and compared to measurements. The differences between theory and experiment are used to detect and correct signal distortion and to determine detector and sound-card characteristics. Corrected signal analysis is found to faithfully reflect known sample parameters.