Sap from various species palm trees in which known as neera generally produced by traditional technology in Indonesia. There are 5 well known palm species that produce Neera in Indonesia such as arenga palm, coconut tree, doub palm, nipa palm and palm oil. Neera can be utilized as raw material for various derivatives such as palm sugar, sweet palm toddy, and alcoholic toddy. Tapping of neera is a crucial step because neera prone to immediately degrade and causing poor quality of palm sugar. Traditional sugar processing has some drawbacks for example: low energy efficiency processing and off-specification products. On the other side, sugar palm neera has important antioxidant component which benefits for human that unavailable in normal white sugar from sugarcane. In this current review, characterization of neera from various palms in Indonesia and available technology on sugar palm processing such as spray dryer and membrane ultrafiltration will be discussed.
Sandy soil has a low ability to absorb and store low water, low nutrient content, and a high water evaporation rate, so it is not suitable to be used as agricultural land. Superabsorbents can be used to overcome these weaknesses. The purpose of this study was to measure the abilities of the superabsorbents, including water holding, swelling, and water retention of sandy soil enriched with superabsorbent, and to analyze the chitosan-graft-poly(acrylic acid) superabsorbent characteristics. The superabsorbent was prepared by mixing a chitosan solution with ammonium persulfate as an initiator and acrylic acid, which had been neutralized with KOH. Then, the mixture was cross-linked with N,N′-methylenebisacrylamide (MBA). The resulting superabsorbent gel was dried in an oven and then crushed for analysis. The results showed that an increase in chitosan concentration increased the gel fraction, swelling, reusability, and water holding. Meanwhile, an increase in chitosan concentration decreased water retention in sandy soils. The swelling kinetics can be predicted using the pseudo-second-order model with high accuracy (R2 value of 0.99).
22 January 2024 in Case Studies in Chemical and Environmental Engineering
The effect of spray dryer inlet temperature on characterization and total phenolic content of palm sugar has been studied. The spray dryer operating conditions used were 160 ̶ 220°C inlet temperature with a feed flow rate of 2 L/hour, while for outlet temperature was 85°C. The high inlet temperature produced a higher crystallinity of sucrose and did not agglomerate and not sticky. However, the high temperature of the spray dryer inlet produced palm sugar that was browner than the low temperature one. The effect of increasing temperature of spray dryer produced irregular total phenolic. The total phenolic at 220°C was higher than 200°C. Likewise, the temperature of 180°C generated total phenolic was higher than the temperature of 160°C. The total phenolic of palm sugar analyzed in this study was quite large within the range of 49 ± 0.01 to 63.6 ± 0.01 mg of GAE/100 g samples.
Tujuan penelitian ini adalah untuk mengetahui pengaruh perbedaan bahan penyalut terhadap efisiensi enkapsulasi oleoresin jahe merah dan analisis karakterisasinya. Proses enkapsulasi diawali dengan melarutkan kitosan dengan asam asetat 1% dan melarutkan sodium alginate menggunakan aquadest yang akan digunakan sebagai bahan penyalut. Oleoresin jahe merah dimasukan dalam larutan alginate kemudian diaduk, setelah itu masukan kedalam larutan kitosan dan diaduk kembali menggunakan homogenizer untuk membuat emulsi sambil ditambahkan tween 80. Emulsi yang terbentuk dimasukan dalam spray dryer untuk dikonversi menjadi bubuk mikrokapsul yang kemudian dihitung efisiensi enkapsulasi dan analisis morofologi mikrokapsul menggunakan scanning electron microscopy (SEM). Perbedaan bahan penyalut yang digunakan yaitu kitosan, campuran kitosan-alginat dan campuran kitosan-alginat-sodium tripolifosfat (STTP). Rasio berat oleoresin dengan bahan penyalut adalah 1:1, 1:2 dan 1:3. Hasil penelitian yang didapat yaitu efisiensi enkapsulasi tertinggi didapat pada bahan penyalut campuran kitosan-alginat-sodium tripolifosfat (STTP) pada rasio 1 : 3 yaitu sebesar 85%.