The current design codes i.e. AISC 360-16, CSA-S16-19, EC-04 etc. provide empirical relationships to estimate the capacity of shear connectors which were developed based on pushout tests of headed studs and channels connectors in exposed type sections. Therefore, these equations may result inaccurate predictions for strength of connectors in infilled-type sections. This study presents a detailed experimental study investigating the performance of angle connectors in composite sections. The testing program consisted two series of pushout tests. A total of 36 specimens were tested, considering the influence of several important parameters i.e. the length (L_c), height (h_c), and web-thickness (t_w) of angle connector, length of the weld (w) and the direction of shear connector (forward/backward) etc. The tests results demonstrated that with increasing connector height h_s, and thickness, the maximum load P_max and slip δu were increased. The connector direction didn't change much the load-slip behavior. The prediction accuracy of the existing shear capacity models was evaluated by comparing the predictions with experimental results. The current equations were noticed to be highly inconsistent in predicting the shear capacity of angle connectors, especially in case of infilled type sections. When the entire length of connector was taken as the effective length, the models overestimated the shear capacity. While in case when the welding length was taken as effective length in calculations, the models underestimated the shear strength of angle connectors.