Most crystalline inorganic materials, except for metals and some layer materials, exhibit bad flexibility because of strong ionic or covalent bonds, while amorphous materials usually display poor electrical properties due to structural disorders. Here, we report the simultaneous realization of extraordinary room temperature flexibility and thermoelectric performance in Ag2Te1–xSx–based materials through amorphization. The coexistence of amorphous main phase and crystallites results in exceptional flexibility and ultralow lattice thermal conductivity. Furthermore, the flexible Ag2Te0.6S0.4 glass exhibits a degenerate semiconductor behavior with a room temperature Hall mobility of ~750 cm2 V−1 s−1 at a carrier concentration of 8.6 × 1018 cm−3, which is at least an order of magnitude higher than other amorphous materials, leading to a thermoelectric power factor also an order of magnitude higher than the best amorphous thermoelectric materials known. The in-plane prototype uni-leg thermoelectric generator made from this material demonstrates its potential for flexible thermoelectric device.
Local thermal magnetization fluctuations in Li-doped MnTe are found to increase its thermopower α strongly at temperatures up to 900 K. Below the Néel temperature (TN ~ 307 K), MnTe is antiferromagnetic, and magnon drag contributes αmd to the thermopower, which scales as ~T3. Magnon drag persists into the paramagnetic state up to >3 × TN because of long-lived, short-range antiferromagnet-like fluctuations (paramagnons) shown by neutron spectroscopy to exist in the paramagnetic state. The paramagnon lifetime is longer than the charge carrier–magnon interaction time; its spin-spin spatial correlation length is larger than the free-carrier effective Bohr radius and de Broglie wavelength. Thus, to itinerant carriers, paramagnons look like magnons and give a paramagnon-drag thermopower. This contribution results in an optimally doped material having a thermoelectric figure of merit ZT > 1 at T > ~900 K, the first material with a technologically meaningful thermoelectric energy conversion efficiency from a spin-caloritronic effect.
With the growing global energy crisis, new methods of energy development and utilization have become the main solutions to energy issues. Solution based polymer thermoelectric (TE) generation technologies provide a low-cost and eco-friendly means of direct energy conversion from low-grade heat to electricity. By integrating high Seebeck coefficient tellurium nanorods with the conducting polymer polyaniline (PANI) to form PANI/Te hybrid films, well-matched nanoscale interfaces improve carrier transport properties yet keep the thermal conductivity at a rather low level of 0.2 W m−1 K−1. Therefore, the originally mutual restricted parameters (electrical conductivity, Seebeck coefficient and thermal conductivity) finally reach an increase in the ZT value. The maximum power factor of the PANI/Te (70 wt%) composite film reached 105 μW m−1 K−2 at room temperature and further reached up to 146 μW m−1 K−2 at 463 K, and the ZT value increased from 0.156 at room temperature to 0.223 at 390 K, which are the highest values reported so far for PANI based TE materials. A screen-printing process was employed to fabricate in-plane power generation devices based on the high-performance PANI/Te hybrid films. A prototype device with 10 legs of PANI/Te–Ag could provide a maximum output voltage and output power of 29.9 mV and 0.73 μW, respectively at temperature gradient 40 K. The results evidently demonstrate a promising and economic route for conducting polymers to be applied in low-grade energy conversion utilization.