This article presents the data-driven equation-free modeling of the dynamics of a hexafloat floating offshore wind turbine based on the application of dynamic mode decomposition (DMD). The DMD has here been used (i) to extract knowledge from the dynamic system through its modal analysis, (ii) for short-term forecasting (nowcasting) from the knowledge of the immediate past of the system state, and (iii) for system identification and reduced-order modeling. All the analyses are performed on experimental data collected from an operating prototype. The nowcasting method for motions, accelerations, and forces acting on the floating system applies Hankel-DMD, a methodological extension that includes time-delayed copies of the states in an augmented state vector. The system identification task is performed by using Hankel-DMD with a control (Hankel-DMDc), which models the system as externally forced. The influence of the main hyperparameters of the methods is investigated with a full factorial analysis using error metrics analyzing complementary aspects of the prediction. A Bayesian extension of the Hankel-DMD and Hankel-DMDc is introduced by considering the hyperparameters as stochastic variables, enriching the predictions with uncertainty quantification. The results show the capability of the approaches for data-lean nowcasting and system identification, with computational costs being compatible with real-time applications. Accurate predictions are obtained up to 4 wave encounters for nowcasting and 20 wave encounters for system identification, suggesting the potential of the methods for real-time continuous-learning digital twinning and surrogate data-driven reduced-order modeling.
The present paper investigates the planar flow past a circular cylinder for Reynolds numbers between 1000 and 10 000. The flow is studied as a dynamical system, so the present investigation is motivated by the presence of complex patterns, as the Reynolds number increases, in the force-time signals when the system goes from the periodic to the chaotic regime. The 2D numerical simulations were performed with a Lagrangian particle method called diffused vortex hydrodynamics (DVH). This computational approach allows high spatial resolutions with an accurate description of different vortical scales shed in the flow field. Flow analysis was executed with the typical tools used in the study of dynamical systems (i.e., Fourier spectra, Poincaré sections, and phase space maps) and is supported by discussion of the near and far wake topologies. During the transition of the system from a regular to a chaotic regime, the lift time signal shows intermittent irregular patterns.
As part of the Sloshing Wing Dynamics H2020 EU project, an experimental campaign was conducted to study slosh-induced damping in a vertically excited tank filled with liquid water or oil and air. In this work, we simulate these experiments using two numerical approaches. First, a single-phase, weakly compressible liquid model is used, and the gas flow (air) is not modeled. For this approach, a proven Smoothed Particle Hydrodynamics (SPH) model is used. In the second approach, both phases are simulated with an incompressible liquid and weakly compressible gas model via a Finite Volume Method (FVM) using Volume-of-Fluid (VOF) to track the liquid phase. In both approaches, the energy distribution of the flow is calculated over time in two- and three-dimensional simulations. It is found that there is reasonable agreement on the energy dissipation evolution between the methods. Both approaches show converging results in 2D simulations, although the SPH simulations seem to have a faster convergence rate. In general, the SPH results tend to overpredict the total dissipation compared to the experiment, while the finite volume 2D results underpredict it. Time histories of the center of mass positions are also compared. The SPH results show a much larger vertical center of mass motion compared to the FVM results, which is more pronounced for the high Reynolds number (water) case, probably linked to the absence of the air phase. On the other hand, the limited center of mass motion of the FVM could be linked to the need for higher spatial resolutions in order to resolve the complex gas–liquid interactions, particularly in 3D.