This paper presents a printed multiple-input multiple-output (MIMO) antenna with the advantages of compact size, good MIMO diversity performance and simple geometry for fifth-generation (5G) millimeter-wave (mm-Wave) applications. The antenna offers a novel Ultra-Wide Band (UWB) operation from 25 to 50 GHz, using a Defective Ground Structure (DGS) technology. Firstly, its compact size makes it suitable for integrating different telecommunication devices for various applications, with a prototype fabricated having a total size of 33 mm × 33 mm × 0.233 mm. Second, the mutual coupling between the individual elements severely impacts the diversity properties of the MIMO antenna system. An effective technique of orthogonally positioning the antenna elements to each other increased their isolation; thus, the MIMO system provides the best diversity performance. The performance of the proposed MIMO antenna was investigated in terms of S-parameters and MIMO diversity parameters to ensure its suitability for future 5G mm-Wave applications. Finally, the proposed work was verified by measurements and exhibited a good match between simulated and measured results. It achieves UWB, high isolation, low mutual coupling, and good MIMO diversity performance, making it a good candidate and seamlessly housed in 5G mm-Wave applications.

A novel circular reconfigurable metasurface (MS) based compact ultra-wideband (UWB) hybrid coupler is developed for Ku-band applications. The coupler is developed using the substrate-integrated gap waveguide (SIGW) technology. The coupler structure consists of two layers, the bottom layer represents the artificial magnetic surface of the periodic structures and the ridges in between that guide the wave in the required direction with minimum dispersion. It involves the coupling section with a centered etched slot and two additional vias to achieve the basic hybrid coupler properties. This layer is nominated as the ridge layer. The second layer is a circular shape of a dielectric gap loaded with the top ground. The top ground is left solid for a non-reconfigurable coupler. Concerning the reconfigurable coupler, this layer contains an artificial metasurface of Jerusalem cross elements where the copper is etched around. This layer is nominated as the gap layer. This MS surface is mechanically rotated to offset the magnitude and phase of the signal going to the through and coupled ports. The findings obtained from the simulations show that the reconfiguration can be accomplished by rotating the MS around the source coupler’s central axis. The rotation is tested between 0° to 180° in the counter-clockwise direction. The operating frequency range of the coupler is between 11.94 to 16.91 GHz, which covers approximately the whole Ku-band. The coupler delivers continuously adjustable amplitude between 2.6 and 4.8 dB while the phase differences within 77° to 105° over a fractional bandwidth (FBW) of 34.45%. It is manufactured using PCB technology and measured using network analyzer. A strong agreement is achieved between simulations and measurements. The proposed coupler can be used in traditional beam-forming and beam-steering networks by changing the rotation angle or the operating frequency. The developed coupler can replace the Butler and Bless matrices with their complication, heavy number of phase shifters, and crossover problems. The current work can be extended to operate in the mm-Wave band by changing the dimension and the material of the unit cell of the ridge layer of the coupler.