Two-dimensional molybdenum disulfide (MoS2) has been extensively investigated in the field of optoelectronic devices. However, most reported MoS2 phototransistors are fabricated using the mechanical exfoliation method to obtain micro-scale MoS2 flakes, which is laboratory- feasible but not practical for the future industrial fabrication of large-scale pixel arrays. Recently, wafer-scale MoS2 growth has been rapidly developed, but few results of uniform large-scale photoelectric devices were reported. Here, we designed a 12 × 12 pixels pixel array image sensor fabricated on a 2 cm × 2 cm monolayer MoS2 film grown by chemical vapor deposition (CVD). The photogating effect induced by the formation of trap states ensures a high photoresponsivity of 364 AW−1, which is considerably superior to traditional CMOS sensors (≈0.1 AW−1). Experimental results also show highly uniform photoelectric properties in this array. Finally, the concatenated image obtained by laser lighting stencil and photolithography mask demonstrates the promising potential of 2D MoS2 for future optoelectrical applications.
28 November 2020 in Optical and Quantum Electronics
Low noise is a significant performance requirement of Hyperspectral Shortwave Infrared Focal Plane Arrays Readout Circuit (ROIC) for its low radiation. And the current Correlated Double Sampling (CDS) technology for noise reduction needs to be further improved. The mechanism of extended reset time CDS, which has an impact on noise, is analyzed; By establishing the "first-order low-pass filter, delay-subtractor, sample-hold" model, the output noise power spectral density of image pixel ROIC as a function of CDS extended reset time is analyzed. To verify the analysis, a pixel integrated with low-noise Capacitive trans-impedance amplifiers (CTIA) and adjustable reset time CDS is designed. By extending the CDS reset time, the simulation result is consistent with the analysis. The number of noise electrons reaches 24.42e-, which is better than 50.11e-without CDS and 34.45e-without extending the reset time. The design of Reset Time Extended CDS can improve the noise performance of hyperspectral readout circuits, and can be widely used.
Low noise is a key requirement of Readout Integrated Circuit (ROIC) in hyperspectral application for its low radiation. The Correlated Double Sampling (CDS) technology is commonly used to suppress the effect of noise. In this paper, CDS is improved by adjusting the time interval between the clamp and sample hold (SH), which can filter low frequency noise flexibly. A ROIC input stage integrated with low-noise Capacitive trans-impedance amplifiers (CTIA) and CDS with adjustable interval (AICDS) is designed. The SPECTRE simulation indicates that, by extending the CDS reset time, the simulation result is consistent with the analysis. The number of noise electrons reaches 32.59 e-, which is better than 56.7 e-without extending the reset time. The design of AICDS can improve the noise performance of hyperspectral ROIC, and can be widely used.