A phase field model was established to simulate the grain growth of Al2O3-based composite ceramic tool materials containing second phase nanoparticles and pores. The free energy parameters of the model are directly related to the surface and grain boundary energies of Al2O3 such that the grain growth process can be quantitatively analysed. The model was used to investigate the effects of the volume fraction and size of second phase particles on grain growth in Al2O3 with a certain initial pore volume fraction. Findings show that pores and second phase particles jointly hinder grain growth. When the radii of second phase nanoparticles are the same, as the number of particles increase, most of the grain boundaries occur as straight lines in the microstructure, and grain size decreases. It is beneficial to obtain fine and uniform microstructure. However, when the particles content reaches a certain level, the second phase particles tend to agglomerate at the grain boundary of matrix grains, which will result in a decrease in the properties of nanocomposite ceramic tool materials. The study also found that, at a constant volume fraction of particles, with the decrease of particle radius, the grain size decreases. When the second phase particle size is reduced to 50 nm, relatively more intragranular microstructure was observed, which is considered to be the main reason for increasing the toughness of nano composite ceramic tool materials. Through analyzing the simulation results, the optimal combination of the content and size of the second phase particles can provide theoretical guidance for Al2O3 nano composite ceramic tool materials design and preparation.
Waste heat air-source heat pump water heater (WH-ASHPWH) systems have been widely used to provide water heating in buildings due to their advantages of high efficiency and low environmental impact. It is important to determine reasonable operating conditions for WH-ASHPWH systems to improve their heating efficiency, especially for systems using industrial waste heat. In this study, a semiempirical parametric model of a WH-ASHPWH system was established to simulate heating performance under different working conditions and determine the optimum operating range of the system. A new discrete model for a tube-in-tube condenser was also generated. Taking the equipment of a pharmaceutical factory as an example, the heat exchanger model was first calibrated; then, the global model was used to study the effects of different air-side and condenser-side waste heat conditions on the heating performance of the system. According to the simulation results, the coefficient of performance (COP) reached a maximum value of 4.5 under the optimum working conditions. The deviation between the COP simulation data and experimental values was less than 8.28%, and the simulation time was less than 8 min. These metrics indicate that the model is reasonable and efficient.
24 January 2026 in International Journal of Refrigeration
In high-temperature, high-pressure, and corrosive industrial environments, frictional wear of metallic components stands as a critical determinant governing the long-term operational reliability of mechanical systems. To address the challenge of traditional lubricating coating failure under a broad temperature range (−50 to 500 °C), this study developed a phosphate-based composite lubricating coating. Through air-spraying technology and orthogonal experimental optimization, the optimal formulation was determined as follows: binder/filler ratio = 6:4, 5% graphite, 15% MoS2, and 10% aluminum powder. Experimental results demonstrated that at 500 °C, the coating forms an Al–O–P cross-linked network structure, with MoS2 oxidation generating MoO3 and aluminum powder transforming into Al2O3, significantly enhancing density and oxidation resistance. Friction tests revealed that the composite coating achieves a friction coefficient as low as 0.12 at room temperature with a friction time of 260 min. At 500 °C, the friction coefficient stabilizes at 0.24, providing 40 min of effective protection. This technology not only resolves the high-temperature instability of traditional coatings but also ensures an environmentally friendly preparation process with no harmful emissions, offering a technical solution for the protection of high-temperature equipment such as thermal power plant boiler tubes and petrochemical reactors.