Zhengjun Pang

Ms. Zhengjun Pang


Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
6 December 2022 in Fermentation
Verified
Journal Article
Open access
PDF file
ZPZhengjun Pang
Zhengjun Pang
YLYuanzi Li
Yuanzi Li
YSYu Shang
Yu Shang
NANawazish Ali
Nawazish Ali
WFWang Fenghuan
Wang Fenghuan
YLYonghong Liao
Yonghong Liao
Lichenysin, an amphiphilic biosurfactant with structural and physicochemical properties similar to surfactin, is produced by Bacillus licheniformis. Its low toxicity, good environmental compatibility, solubilization, foaming, emulsification and detergent activities have led to a wide range of applications in agricultural biocontrol, enhanced oil recovery, foaming agents for cosmetics and detergents for household cleaning products. However, despite the extraordinary surface-active properties and potential applications of lichenysin, the number of wild bacteria found so far is relatively low. Low titers and high costs are the main limiting factors for widespread industrial applications. In this study, a factorial design was used to optimize the composition of the medium for the production of lichenysin by Bacillus licheniformis Ali5. Firstly, the solutions of carbon, nitrogen, amino acids, inorganic salts and trace elements in the medium were evaluated in flasks using a single-factor optimization method. Meanwhile, the operating conditions were optimized in the same way. Afterwards, a partial factorial design was used to investigate the effect of six variables (five medium compositions and inoculum size) on lichenysin production. Based on the results obtained, the concentrations of sucrose and ammonium nitrate and the inoculum size were considered to be important for lichenysin production. Subsequently, a full factorial design was used to optimize these three variables. The optimized medium composition were sucrose 19.8 g/L, NH4NO3 3.9 g/L, K2HPO4·3H2O 4.0 g/L, MgSO4·7H2O 0.6 g/L, FeSO4·7H2O 0.1 g/L, CaCl2 0.01 g/L, NaCl 3.0, trace elements 1.2 mL/L. Finally, the titer of lichenysin after fed-batch fermentation reached 1425.85 mg/L, which was approximately 5.5 times higher than the titer of lichenysin from the original medium. Consequently, the method was further demonstrated to be suitable for lichenysin production.

23 February 2026 in Foods
Verified
Journal Article
Open access
PDF file
BZBo Zhang
Bo Zhang
LZLingzhi Zhang
Lingzhi Zhang
ZPZhengjun Pang
Zhengjun Pang
WZWenshuo Zhang
Wenshuo Zhang
WFWang Fenghuan
Wang Fenghuan
BZBolin Zhang
Bolin Zhang
Fruit spoilage caused by fungal pathogens jeopardizes food safety and inflicts significant economic damage. Cyclic lipopeptides (CLPs) have been applied as biofungicides by disrupting the cell membrane and intracellular components; however, the first target for antifungal action is the fungal cell wall. This study elucidates the molecular mechanism by which CLPs compromise cell wall integrity using molecular dynamics simulation and experimental validation. Among Surfactin C, Iturin A, and Fengycin A, Surfactin C exhibited the strongest binding to β-glucan (ΔE = −1970.536 kcal/mol) and the lowest free volume (7.302%), with enhanced effects at higher concentrations. Key interaction sites were identified at C=O of D-Leu3, -N-H of Leu2, and -COOH of Glu1 by Radial distribution function. In vivo assays with Aspergillus niger confirmed a MIC of 40 µg/mL and Surfactin-induced β-glucan exposure. FTIR and XPS analyses revealed structural reorganization and hydrogen bonding, while SEM/TEM showed spore deformation and wall rupture. These findings demonstrate that Surfactin disrupts fungal cell walls via direct complexation with β-glucan, leading to structural collapse and cell death, supporting its potential as a targeted biofungicide.