Shape memory alloys (SMAs) are a class of functional materials that possess unique thermomechanical properties, such as shape memory effect (SME), superelasticity (SE), damping, and good fatigue and corrosion resistance, which enable them to become ideal materials for applications in earthquake engineering. Numerous studies have shown that the mechanical properties of superelastic SMAs mainly depend on the wire form, or the relationship between the microstructure and thermally induced phase transitions. However, extremely few studies have elucidated the effects of the heat-treatment strategy, size effect of large diameters, and cyclic loading. Herein, the mechanical properties of SMA bars, such as residual strain, energy dissipation, and equivalent damping ratio, were studied with different heat-treatment strategies, cyclic loadings, and strain amplitudes; this was achieved by conducting cyclic tensile tests on SMA bars with four different diameters. The results indicate that the maximum phase transformation stress was obtained with a 14 mm SMA bar subjected to heat treatment at 400 ℃ for 15 min. The mechanical properties were relatively stable after five loading–unloading cycles, which should be considered in engineering applications. The test results provide a mechanical basis for using large SMA bars in self-centering structures in seismic regions.
12 March 2024 in Construction and Building Materials
In order to research the flexural behavior of shape memory alloy (SMA)-reinforced seawater sea-sand concrete (SWSSC) beams and improve their self-healing ability, three SMA SWSSC beams and one anti-corrosive steel bar SWSSC beam were designed. The influence of the reinforcement ratio, strength grade of SWSSC and type of reinforcement on the flexural performance of the beam were considered. The failure process, maximum crack width, mid-span deflection, displacement ductility and stiffness degradation of beams were studied by cyclic loading tests. The test results showed that the number of cracks in SMA-reinforced beams were significantly smaller than that in anti-corrosive-reinforced beams, and the crack width and mid-span deflection recovery effect were better after unloading. However, the effect of increasing the SMA reinforcement ratio on crack recovery was not obvious. The increase in SMA reinforcement ratio and the strength grade of SWSSC can significantly improve the bearing capacity of the beam and the stiffness, but the stiffness degradation rate decreased. Moreover, the ductility of concrete beams with SMA bars was significantly increased.
26 December 2025 in Construction and Building Materials