Despite the improved conversion efficiency of Cu2(ZnSn)Se4 (CZTSe) solar cells, their roll-to-roll fabrication nonetheless leads to low performance. The selenization time and temperature are typically considered major parameters for a powder-based CZTSe film; meanwhile, the importance of the densification during the roll-to-roll process is often overlooked. The densification process is related to the porosity of the light-absorbing layer, where high porosity lowers cell performance. In this study, we fabricated a dense CZTSe absorber layer as a method of controlling the compression of a powder precursor (Cu1.7(Zn1.2Sn1.0)S4.0 (CZTS)) during the roll-press process. The increased particle packing density of the CZTS layer was crucial in sintering the powder layer into a dense film and preventing severe selenization of the Mo back electrode. The pressed absorber layer of the CZTSe solar cell exhibited a more uniform chemical composition determined using dynamic secondary ion mass spectrometry (SIMS). Under the AM 1.5G illumination condition, the power conversion efficiency of the pressed solar cell was 6.82%, while the unpressed one was 4.90%.
Cubic boron nitride ( c ‐BN) and hexagonal boron nitride ( h ‐BN) are known for their transparency and high 10 B density, which provides a large thermal‐neutron cross‐section, yet their potential for space neutron shielding has not been explored. The fabrication of transparent c ‐BN films remains challenging, and the chemical vapor deposition growth of h ‐BN beyond 70 nm, or with precise thickness control and high uniformity, has not been reported except by our group. Here, we present a space window design integrating an h ‐BN‐based neutron shielding layer with advanced ceramic bulletproof layers and a γ‐ray shielding layer. By incorporating C and O into h ‐BN, sp 2 ‐sp 3 hybridized BN (HBN) reduces the refractive index mismatch with the SiO 2 substrate, achieving 90.9% transmission at 550 nm at 11.9 µm thickness and enabling stable, transparent growth up to 79.2 µm with minimized thermal expansion mismatch. The optically optimized HBN (B 0.39 N 0.39 C 0.06 O 0.16 ) shows reduced boron content, but the enriched formation of 63.4% c ‐BN, with its higher boron density, compensates for this loss. The resultant density is 3.01 g cm −3 , evaluated from neutron‐shielding probability, and HBN achieves the same neutron‐shielding efficiency as h ‐BN at 3% reduced thickness.
Hexagonal boron nitride (hBN) has emerged as a leading host for room‐temperature quantum light emission in 2D platforms, which enables facile integration with various photonic devices. However, scalable hBN growth is often restricted to ultrathin films and limited substrate choices, making transfer steps necessary for practical device integration. Here, we report catalyst‐free chemical vapor deposition of thickness‐controlled hBN films directly on CMOS‐compatible SiO 2 /Si substrates, enabling transfer‐free, large‐area growth of hBN hosting single‐photon emitters (SPEs). By systematically tuning the growth parameters, we engineered the SPE density from 2 × 10 7 to 7 × 10 7 cm −2 , and identified the optimal growth condition to yield the highest emitter density. Photophysical measurements confirm high‐purity emission with g 2 (0) down to 0.09 without background correction. Importantly, SPEs are well‐isolated in substantially thick hBN layers up to 100 nm, providing a device‐relevant thickness regime for optical mode confinement and fabrication of integrated photonic architectures. These results provide a scalable route to integrate hBN‐hosted quantum light sources on silicon platforms for large‐area quantum photonic devices.