The pseudopotential lattice Boltzmann method (LBM) becomes popular in simulating the boiling heat transfer problems. By using the interaction force determined from an equation of state, the boiling phenomenon can occur spontaneously according to the thermodynamics, which avoids using empirical models for boiling. However, this pseudopotential interaction model also brings additional cause of instability, which becomes severe at high density ratios. Therefore, most of its previous boiling simulations are conducted at high saturated temperatures with low density ratios. Since the instability usually stems from the disturbance at the interfaces, we investigated the scheme of computing the solid pseudopotential for the solid–fluid interaction and proposed using the average surrounding fluid properties as the virtual solid temperature in addition to density. Droplet evaporation and film boiling problems at high saturated temperatures are simulated, and very good agreement is obtained when compared with the available numerical and analytical solutions, respectively. We then applied the pseudopotential LBM model to simulate droplet evaporation and pool boiling at a low reduced temperature of Tr=0.592 with a density ratio of 1000, as demonstrations of the improved numerical stability. Different boiling regimes are observed by varying the superheat imposed at the bottom wall.
Small-sized droplets/aerosol transmission is one of the factors responsible for the spread of COVID-19, in addition to large droplets and surface contamination (fomites). While large droplets and surface contamination can be relatively easier to deal with (i.e., using mask and proper hygiene measures), aerosol presents a different challenge due to their ability to remain airborne for a long time. This calls for mitigation solutions that can rapidly eliminate the airborne aerosol. Pre-COVID-19, air ionizers have been touted as effective tools to eliminate small particulates. In this work, we sought to evaluate the efficacy of a novel plant-based ionizer in eliminating aerosol. It was found that factors such as the ion concentration, humidity, and ventilation can drastically affect the efficacy of aerosol removal. The aerosol removal rate was quantified in terms of ACH (air changes per hour) and CADR- (clean air delivery rate-) equivalent unit, with ACH as high as 12 and CADR as high as 141 ft 3 /minute being achieved by a plant-based ionizer in a small isolated room. This work provides an important and timely guidance on the effective deployment of ionizers in minimizing the risk of COVID-19 spread via airborne aerosol, especially in a poorly-ventilated environment.
30 October 2023 in International Journal of Thermal Sciences