The purpose of this study is to comparatively investigate the wear behavior of nickel-based superalloy surfaces induced by mechanical polishing and grinding using the contact fretting against YG6 cemented carbide balls. Experimental results indicate that the friction coefficient and wear volume of the ground surface of nickel-based superalloy are smaller by 7.3% and by 18% on average, respectively, than those of the polished one. Furthermore, the high fretting wear loss of polished nickel-based superalloy can be attributed to the wear recirculation process composed of the plastic deformation, oxidization wear, surface and subsurface micro crack, which eventually leads to the significant material peeling and fatigue delamination. However, the ground nickel-based superalloy presents mainly the abrasive wear and excellent fretting wear-resistance due to the high hardness induced by grinding and the completely continuous compacted debris layer with few cracks instead of the ground surface to contact with the counterpart ball. Obtained results are beneficial for deepening the understanding of degradation mechanism during fretting of the nickel-based superalloy surfaces prepared by mechanical grinding and polishing.
Gradient structures have been created in single crystal nickel-based superalloys (SX alloys) via surface mechanical creep-feed grinding treatment (SMCGT). It has been found that these gradient structures are mainly composed of nano-sized grains, sub-micron-sized grains, dislocation structures, and the matrix material of single crystals along the depth from the treated surface. In addition, the evolution of such structures is found to be dominated by the dislocation movements which run through both γ channels and γ’ precipitates, subdividing the two types of microstructures into various dislocation structures, and eventually introducing the refined grains into the surface layer. Furthermore, the evolution process of gradient structures primarily originates from the mechanical effect between abrasive grits and workpiece material, owing to the large grinding force (up to 529 N) and low grinding temperature (less than 150 °C) during the unique creep-feed grinding treatment in the present investigation. Due to the typical grain refinement, the hardness of the nanostructures exhibits the largest value of around 10 GPa in the surface layer, approximately 26% higher than that of the matrix material. This study further enhances the understanding of the microstructure–property relationship of SX alloys subjected to creep-feed grinding treatment and contributes to achievement of high-performance components.
The advanced aircraft turbine blades are extensively fabricated by single-crystal nickel superalloys because of their excellent high-temperature strength and outstanding fatigue resistance (Dang et...