Feldspar dissolution and precipitation of clays and quartz cements are important diagenetic reactions affecting reservoir quality evolution in sandstones with detrital feldspars. We examined two sets of sandstone reservoirs to determine whether the sandstone diagenetic systems were open or closed to the mass transfer of products from feldspar dissolution and its impact on reservoir quality. One of the reservoirs is the Eocene fan delta sandstone buried 2.5–4.0 km (1.5–2.5 mi) below sea level (BSL) in the Gaoliu (GL) area of the Nanpu sag, and the other is the Eocene subaqueous fan sandstone buried 1.5–4.5 km (1–2.8 mi) BSL in the Shengtuo (ST) area of the Dongying sag. Both sandstones consist mainly of lithic arkoses and feldspathic litharenites, and have secondary porosity formed by dissolution of feldspars. In the GL sandstones, the absolute amounts of authigenic clays and quartz cements (generally 125°C [257°F]). The low abundance of authigenic clays and quartz cements, and low pore-water salinity indicate that much of the K+, Al3+, and SiO2(aq) released from leached K-feldspars were exported from the GL sandstone system. And the extensive feldspar dissolution enhanced much porosity and permeability. In contrast, the ST sandstones with secondary pores formed by feldspar dissolution generally contain authigenic clays (kaolinite and illite) and quartz cements with almost identical volume of secondary pores. Kaolinite dominates in the ST sandstones at shallower depth (3.1 km [2 mi] BSL) where temperature exceeds 125°C (257°F). The presence of abundant clays and quartz cements indicates that Al3+ and SiO2(aq) released from leached feldspars were retained in the ST sandstone system. The dominance of authigenic illite at greater depth indicates that sufficient K+ should have been retained within the sandstones for occurrence of illitization of kaolinite and feldspars. Secondary porosity in thin sections can be up to 3%, but little porosity (<0.25%) is enhanced. Primary macropores are lost as clays and quartz precipitate whereas the proportion of microporosity increases, occurring mainly between clay crystals. The overall result is that permeability is degraded. The diagenetic difference between the GL and the ST sandstones can be interpreted by assessing pore-water evolution in these two areas. The current pore waters with low salinity and negative hydrogen isotopic compositions in the GL sandstone system indicate the significant impact of meteoric water, whereas the current pore waters with high salinity and the paleofluids with positive oxygen isotopic compositions in the ST sandstone system indicate little trace of meteoric water. Access of meteoric freshwater to the GL area probably occurred during the late Oligocene to Neogene through widely developed faults in the Paleogene and Neogene strata. The low-salinity water could have been responsible for flushing of solutes derived from feldspar dissolution. As such, diagenesis in the GL sandstones is considered to have occurred in an open geochemical system, whereas with limited faults and high water salinity, the ST sandstones acted as a closed geochemical system where precipitation of kaolinite, illite, and quartz cements occurred following dissolution of feldspars.

Dissolution of feldspars and precipitation of secondary minerals (kaolinite, illite and quartz) are significant diagenetic processes in arkosic sandstones. We examined moderately buried sandstones in the Eocene Shahejie Formation from two sags in the Bohai Bay Basin, East China. Three different types of mineral assemblages (MA) were identified: extensively leached feldspars with a large amount of authigenic kaolinite and quartz cement (MA-1), extensively leached feldspars with a large amount of authigenic kaolinite and minor quartz cement (MA-2), and extensively leached feldspars with a small amount of both authigenic kaolinite and quartz cement (MA-3).\ud \ud Numerical simulations at the continuum scale using Geochemist’s Workbench 9.0 were conducted to decipher the origin of the different mineral assemblages. The physicochemical reactions including feldspar dissolution, transport of Al3+ and SiO2(aq), and precipitation of kaolinite and quartz are coupled together in these simulations, with constraints of chemical reactions, kinetic law, dispersion, and advection. Modeling results suggest that a dissolution zone, a transitional zone, and a precipitation zone can be formed in a sandstone unit with suitable constraints of temperature, flow rate, fluid composition and mineral reaction rate. And MA-3, MA-2, and MA-1 assemblages develop in these three zones respectively. The higher SiO2(aq) concentration required for the saturation of quartz than for kaolinite and the low Al3+ concentration needed for the saturation of kaolinite lead to the precipitation of only kaolinite in the transitional zone in a geochemical system with feldspar dissolution serving as the dominant source of SiO2(aq) and Al3+.\ud \ud Comparisons between modeling results and observations of natural sandstone diagenesis suggest that an MA-1 assemblage is likely to occur in buried sandstones at high temperatures (>70–80 °C) and low flow rates. An MA-2 assemblage may occur in moderately buried sandstones at moderate temperatures (40–70 °C), in deeply buried sandstones with faults and fractures serving as conduits of meteoric freshwater, or in shallow sandstones where meteoric water is not abundant. An MA-3 assemblage tends to occur in shallow sandstones at low temperatures (<40–50 °C) and high flow rates, or in buried sandstones where faults and fractures develop widely and serve as freshwater conduits. These proposals are valid in natural arkosic sandstones and of great significance in deciphering the diagenetic environments where the feldspar dissolution and secondary mineral precipitation have occurred