The phase change material is a hot research topic in solar thermal storage systems. However, the thermal conductivity of pure phase change materials is usually low, which hinders its application in facilities. In this study, copper foam is used to increase the thermal characteristics of the paraffin. Simulations are conducted to compare the melting characteristics of the pure paraffin and the paraffin/copper foam composite phase change material. A visualized experimental device was designed and built, and the copper foam composite phase change material, with a volume fraction of 15%, was prepared by filling part of the copper foam in the phase change material. The simulation results agree well with the experimental results. The root mean square errors of the temperature for the pure paraffin and the composite phase change material are 0.0223 and 0.0179, respectively. The experimental results show that the copper foam can enhance thermal conductivity and decrease melting time. It takes 870 s for the composite phase change material to melt, which is 3.44% less than that of the pure paraffin. This study deepens the understanding of the composite phase change material and provides a reference for the design of thermal energy storage devices.
Phase change material (PCM) water tanks have a major influence on the efficiency improvement of solar energy systems. This article discusses the effects of PCM under various inlets in a tank based on related research. So as to research the performance of the water storage tank, this paper built a set of water tank experimental systems using sodium acetate trihydrate. The thermal characteristics of two different water tanks were analyzed at 2, 6 and 10 L/min when the inlet temperature was 20 °C and the initial high temperature was 80 °C. The test results indicate that adding PCMs helps to provide an extra 1.4% of stored heat, prolong the hot water outlet time, and has a better thermal stratification, compared with ordinary water tanks. However, PCMs do not give off heat quickly at high flow rates. Besides the exergy efficiency (EE) gradually decreasing, the MIX number first decreases and then increases; the fill efficiency (FE) has the opposite trend with the flow increasing. FE has a max of 0.905 at 6 L/min.