Ligang Zhang

Ligang Zhang


Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
5 January 2023 in Aerospace
Verified
Journal Article
Open access
PDF file
NQNanxuan Qiao
Nanxuan Qiao
TMTielin Ma
Tielin Ma
Jingcheng FUJingcheng FU
Jingcheng FU
LZLigang Zhang
Ligang Zhang
XWXiangsheng Wang
Xiangsheng Wang
PXPu Xue
Pu Xue
The rising interest in the evolvability of electric vertical takeoff and landing (eVTOL) promises substantial potential in the field of urban air mobility (UAM). Challenges in energy storage density and geometry restriction both emphasize the propeller efficiency for endurance and takeoff weight, whereas the contra-rotating propellers (CRP) advantage is balancing high thrust and efficiency over a single propeller. The aim of this paper is twofold: (i) to present a novel rapid CRP blade shape optimization framework and (ii) to study the impact of the dual propellers revolution speed allocations on the overall CRP power efficiency. The core of the framework is the blade element momentum theory (BEMT)-based blade shape optimization considering the wake effect of the upper propeller by the rotational CFD (computational fluid dynamics) actuator-disc simulation method. The results show that for the same thrust, the optimized CRP at the equal revolution speed is superior to the original (upper-lower-identical) one by 5.9% in thrust-to-power ratio. The overall efficiency can be additionally lifted by 5.3% when the dual propellers share similar torques. By excluding the integral propeller CFD simulation and empirical parameters estimation, the framework enables the swift obtaining of an optimized CRP scheme while maintaining robustness as well.

6 November 2024 in IEEE Access
Verified
Journal Article
Open access
XWXiangsheng Wang
Xiangsheng Wang
TMTielin Ma
Tielin Ma
LZLigang Zhang
Ligang Zhang
Air-launched deployments of Unmanned Aerial Vehicle (UAV) swarms cause a broad spatial distribution among members, resulting inconsistencies in potential energy and wind conditions during flight. To optimize flight performance during swarm rendezvous, this paper proposes a trajectory planning method that enables members harvest wind energy. Integrate wind energy harvesting strategies for single vehicles with the spatial-temporal coordination of the swarm system. This strategy efficiently manages wind, mechanical, and electrical energies, thereby extending their endurance and range. This method is formulated using the Optimal Control Problem (OCP) framework, considering the dynamics of the swarm system. To ensure control input continuity and trajectory feasibility, the method incorporates constraints on thrust and its increment, which reduces the number of collocation points and lessens computational burden when the OCP is converted into a Nonlinear Programming (NLP) problem for solving. The optimal trajectory of a single UAV is employed as the initial guess to accelerate convergence and enhance solution global optimality. The trajectory planning results demonstrate that, to achieve mechanical energy consistency during the rendezvous process, members with differing initial potential energies after air-launch employ independent wind energy harvesting strategies to compensate for trajectory energy costs. This method optimally plans collaborative trajectories for multiple vehicles within spatiotemporal constraints, significantly broadening their reachable domain. The comprehensive management of energy reserves from air-launched vehicles, including potential and electrical energy, along with the harvesting of wind energy, can significantly extend the range and endurance of air-launched swarm missions.

8 December 2025 in Drones
Verified
Journal Article
Open access
PDF file
JZJiahui Zhang
Jiahui Zhang
JXJinwu Xiang
Jinwu Xiang
Daochun LiDaochun Li
Daochun Li
GYGang Yang
Gang Yang
WDWeicheng Di
Weicheng Di
Zhan TuZhan Tu
Zhan Tu
As a classical disturbance observation method, the extended state observer (ESO) is commonly used in controllers for disturbance estimation and feedback control. However, the ESO relies mainly on input–output signals and does not fully utilize information from system derivatives and the system’s dynamic structure. This underuse limits its effectiveness for vertical take-off and landing (VTOL) uncrewed aerial vehicles (UAVs). This limitation is especially problematic in small tailless VTOL UAVs (ST-VTOL UAVs). While these UAVs can switch modes and operate in confined spaces, they are highly susceptible to disturbances such as wind. To address this issue, this paper applies a novel disturbance rejection controller to an ST-VTOL UAV. Specifically, the controller replaces the traditional linear ESO with an enhanced state compensation function observer (SCFO) and integrates it with an equivalent sliding mode controller (ESMC). Simulation results demonstrate that the SCFO achieves substantially higher disturbance-estimation accuracy than both the classical ESO and its fal–function–enhanced variant. Flight experiments on the ST-VTOL UAV confirm that the proposed method reduces tracking error compared with a conventional PID controller and maintains stable hovering under external disturbances.

28 November 2024 in Drones
Verified
Journal Article
Open access
PDF file
XWXiangsheng Wang
Xiangsheng Wang
TMTielin Ma
Tielin Ma
LZLigang Zhang
Ligang Zhang
NQNanxuan Qiao
Nanxuan Qiao
PXPu Xue
Pu Xue
Jingcheng FUJingcheng FU
Jingcheng FU
Small air-launched unmanned aerial vehicles (UAVs) face challenges in range and endurance due to their compact size and lightweight design. To address these issues, this paper introduces a multi-phase wind energy harvesting trajectory planning method designed to optimize the onboard electrical energy consumption during rendezvous and formation flight of air-launched fixed-wing swarms. This method strategically manages gravitational potential energy from air-launch deployments and harvests wind energy that aligns with the UAV’s flight speed. We integrate wind energy harvesting strategies for single vehicles with the spatial–temporal coordination of the swarm system. Considering the wind effects into the trajectory planning allows UAVs to enhance their operational capabilities and extend mission duration without changes on the vehicle design. The trajectory planning method is formalized as an optimal control problem (OCP) that ensures spatial–temporal coordination, inter-vehicle collision avoidance, and incorporates a 3-degree of freedom kinematic model of UAVs, extending wind energy harvesting trajectory optimization from an individual UAV to swarm-level applications. The cost function is formulized to comprehensively evaluate electrical energy consumption, endurance, and range. Simulation results demonstrate significant energy savings in both low- and high-altitude mission scenarios. Efficient wind energy utilization can double the maximum formation rendezvous distance and even allow for rendezvous without electrical power consumption when the phase durations are extended reasonably. The subsequent formation flight phase exhibits a maximum endurance increase of 58%. This reduction in electrical energy consumption directly extends the range and endurance of air-launched swarm, thereby enhancing the mission capabilities of the swarm in subsequent flight.