Using the batch adsorption technique, an eco-friendly polymer composite made of chitosan, polyaniline, and iron (III) oxide was developed for removal of dye contamination from wastewater. Ultraviolet-visible spectroscopy (UV-Vis), Fourier transform infrared spectroscopy (FTIR), scanning electron microscopy (SEM), X-ray diffraction (XRD), transmission electron microscopy (TEM), EDX (energy dispersive X-ray analysis), and thermogravimetric-derived thermogravimetric (TG-DTG) techniques were used to characterize the sample. According to EDX, the Ch-PANI-Fe2O3 hybrid composite has the following weight ratios: C 34.25%, N 0.48%, O 50.51%, and Fe 3.08%. The nanocomposite’s surface was rough with pleats, which was evident from the SEM and TEM images. This surface structure likely contributed to the nanocomposite’s higher dye adsorption rate (91.5%). According to SEM analysis, the proportion of Fe2O3 nanoparticles to the chitosan–polyaniline composite changed the hybrids’ morphology from granular to an irregular, globular-like structure, which was supported by EDX. The results demonstrated that this polymer matrix (chitosan-PANI-Fe2O3) nanocomposite can be employed as an adsorbent for the effective removal of methyl orange dye, as well as for the removal of dye contamination from wastewater with reusability.
An ecofriendly polymer composite based on chitosan, polyaniline and manganese dioxide has been prepared using batch adsorption method and analyzed by Fourier transform infrared (FTIR), UV-vis, X-ray diffraction (XRD), scanning electron microscopy (SEM) and transmission electron microscopy (TEM). FTIR results suggested the presence of functional groups like hydroxyl and amino groups and also shown a significant shift in IR bands in CS-PANI-MnO2 composite. The surface of composite was quite rough within the folds of pleated regions as observed from the SEM and TEM morphologies. The prepared composite was also utilized as an adsorbent for the treatment of methyl orange from the aqueous solution and achieved a reasonably good adsorption capacity of 96.2%. The biochemical oxygen demand (BOD) and chemical oxygen demand (COD) tests also suggested their suitability for the adsorption of methyl orange dye.