Yang Li

Yang Li


Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
30 December 2022 in Polymers
Verified
Journal Article
Open access
PDF file
YLYang Li
Yang Li
ZGZhicong Gu
Zhicong Gu
BZBen Zhao
Ben Zhao
JZJiangkun Zhang
Jiangkun Zhang
XZXu Zou
Xu Zou
Basalt fiber (BF) has received much attention in recent years for engineering practice and scientific research related to basalt fiber reinforced concrete (BFRC) due to its advantageous mechanical properties and cost-effectiveness. By researching its performance characteristics after cryogenic freeze–thaw cycles, the advantages of BFRC’s mechanical properties can be further exploited in order to expand its application scope. The effects of the fiber volume fraction, temperature gradient, and number of freeze–thaw cycles on the compressive strength, toughness index, splitting tensile strength, flexural strength, etc., of BFRC were investigated. Additionally, the damage mechanism of BFRC after freeze–thaw cycles was analyzed via scanning electron microscopy (SEM). The results show that the compressive strength of BFRC reaches its peak value when the fraction reaches 0.1% under the conditions of freezing and thawing cycles from room temperature to −80 °C. When the fraction of BFRC is 0.1%, and the maximum reduction is 17.1%, the splitting tensile strength decreased most sharply when the fraction was 0.1%, and the decrease amplitude was 40.9%, and the flexural strength decreased most acutely when the fraction was 0.3%, and the maximum decrease was 44.62%. The addition of basalt fibers can reduce the damage to the microstructure of concrete and improve its plastic degradation characteristics to a certain extent. With a decrease in the minimum temperature of the cryogenic freeze–thaw cycle, the optimal fiber content for compressive strength increases. Nevertheless, the splitting tensile strength and flexural strength of BFRC is improved as the fiber content increases under the cryogenic freeze–thaw environment.

13 April 2025 in Arabian Journal for Science and Engineering
Verified
Journal Article
Closed access
PDF file
YLYang Li
Yang Li
YCYongqi Chen
Yongqi Chen
JHJunhui He
Junhui He
WHWei Hu
Wei Hu
YWYifan Wang
Yifan Wang
XPXiaofang Peng
Xiaofang Peng

30 August 2025 in Multiscale and Multidisciplinary Modeling, Experiments and Design
Verified
Journal Article
Closed access
PDF file
YLYang Li
Yang Li
WHWei Hu
Wei Hu
SJSibo Jiang
Sibo Jiang
YCYongqi Chen
Yongqi Chen
NSNana Song
Nana Song
CYChaojie Yuan
Chaojie Yuan

17 November 2025 in Environmental Research
Verified
Journal Article
Closed access
YCYongqi Chen
Yongqi Chen
YLYang Li
Yang Li
YMYibin Mao
Yibin Mao
JZJiangkun Zhang
Jiangkun Zhang

17 June 2026 in Buildings
Verified
Journal Article
Open access
PDF file
ZWZirui Wang Zirui Wang
Zirui Wang Zirui Wang
ZJZhiwei Jiang
Zhiwei Jiang
YLYang Li
Yang Li
MLMengqi Li
Mengqi Li
YYYangyang Yang
Yangyang Yang
Biao LiBiao Li
Biao Li
Geopolymeric concrete beams are gaining increasing attention as sustainable structural members. The paper presents an experimental investigation on the deflection and cracking behavior of geopolymeric recycled aggregate concrete (GRAC) beams, with emphasis on effects of the longitudinal reinforcement ratio and the recycled aggregate (RA) replacement ratio. Using digital image correlation (DIC) technology, the failure modes, load–deflection curves, deflection characteristics, stiffness, and cracking behavior were systematically analyzed. The results indicated that increasing the reinforcement ratio leads to the same trend in GRAC beams as that observed in ordinary reinforced concrete beams. At 50% RA replacement, GRAC beams exhibit improved cracking resistance, 13.41% higher cracking stiffness, 6.93% lower deflection, and enhanced ductility compared to specimens without RA, attributed to the enhanced RA–matrix interface. However, a further increase in the RA replacement ratio leads to poorer flexural performance of the GRAC beams. In addition, predictive models for cracking moment, stiffness, deflection, and maximum crack width of GRAC beams were proposed based on the experimental results, incorporating the plastic influence coefficient, the comprehensive coefficient for the average strain at the extreme compression zone of concrete and the maximum crack width correction factor. The calculated values agreed well with the test data, offering a basis for structural design and engineering application.