Optical and scanning electron microscopy, as well as electron microprobe analysis and electron backscatter diffraction, have been used to study diffusion processes that occur in a diffusion pair that consistsof a single-crystal CMSX-10 nickel-base superalloy and polycrystalline nickel, at temperatures of 1050–1250°C. It has been found that, in this system, the distributions of γ-stabilizing elements (Cr, Co, W, and Re) are described by the Boltzmann solution for diffusion between two semiinfinite plates of a binary alloy. The processing of these distributions has shown that the diffusion coefficients of Cr, Co, W, and Re in the multicomponent system are close to those in binary alloys of these elements with Ni. The diffusion redistribution of the elements leads to the dissolution of the γ′ phase in the nickel-base superalloy, growth of nickel grains toward the superalloy constituent of the diffusion pair, and the formation of porosity on both sides of the migrating interface, which is determined from a crystal misorientation of the alloy single crystal and nickel grains.
28 February 2015 in Physics of Metals and Metallography
Processes of interdiffusion have been studied in the Ni-Re system. The method of electron-microprobe analysis was used to measure the interdiffusion coefficients D̃ in Ni4.4Re/Ni, Ni7Re/Ni Ni9Re/Ni, and Ni9Re/Ni4.4Re (wt %) diffusion pairs in the temperature range of 1050–1350°C. The averaged values of the preexponential factor and the activation energy for interdiffusion were found to be D0 = 1.16 × 10−4 m2/s and Q = 317 kJ/mol, respectively. The value D0 ∼ 10−4 m2/s is typical of substitutional alloying elements in fcc metals; the value of Q is determined to be close to that for W and is significantly higher than those that correspond to other alloying elements in nickel superalloys. No clearly pronounced concentration dependence of the coefficients of interdiffusion has been revealed at a rhenium concentration of 4.4–9 wt %.
1 April 2009 in Russian Journal of Non-Ferrous Metals
The grain boundary diffusion (GBD) of copper in aluminum is investigated in the range t = 300−400°C. Investigations were performed on a scanning electron microscope equipped with an attachment for electron probe X-ray microanalysis. The triple product sδDgb (where s is the segregation coefficient, δ is the width of the grain boundary, and Dgb is the GBD coefficient) was calculated by the Fisher criterion using two methods (namely, the copper concentration in the grain boundary, depending on the penetration depth, was determined and the angles in the vertex of the concentration profile was measured using an optical microscope). In the first case, sδDgb was 5.1 × 10−11 exp(−102/(RT)) m3/s; in the second case it was 1.4 × 10−11 exp(−94/(RT)) m3/s. The obtained results are compared with innumerous literature data.
24 November 2017 in Physics of Metals and Metallography
Studies of the processes that occur upon the interdiffusion in the aluminum−copper system in the temperature range of 320–440°C have been carried out using optical metallography, scanning electron mic