The development of portable electronic devices has increased; this development needs to be accompanied by the development of reliable power sources. In this study, two different vortex combustor sets were used in conjunction with a thermoelectric generator to determine their energy output. This study focuses on the development of a meso-scale vortex combustor to obtain the electric energy for a micro power generator; different materials and different vortex designs are analyzed. Numerical and experimental methods have been used to analyze the development of the vortex combustor. A horizontal vortex combustor made from stainless steel had higher wall temperature and voltage output measurements. To analyze the energy output for the micro power generator, a single TEG and double TEG are analyzed; according to the results, a double TEG with a water-cooled system has the highest electric power compared with the other results.
The flame stabilization limit on micro-combustor had studied to support the micro power generator system. Micro-combustion became the crucial components in a micro power generation system as heat resource that will be converted into electricity. However, the unstable flame in micro-combustor became the main problem that faced by researchers, especially the excess of heat losses. The objective of this study is to observe the flame stabilization limit in a rearward facing step micro-combustor. This study was focused on the effect of micro-combustor material and flame stabilization through the numerical simulation. The micro-combustor material that was used in this study is quartz glass and stainless steel. Micro-combustor was divided into unburned region and burned region. The dimensions of micro-combustor are 3.5 mm inner diameter of unburned region, 4.5 mm inner diameter of burned region and 1 mm thickness. The results have shown that the material of micro-combustor and model of the flame holder have direct relationship with the characteristics of flame stabilization in the micro-combustors. The effects of the flame holder designs and micro-combustors dimensions on the flame stabilization were discussed in detail in this paper.
A meso-scale vortex combustor has been designed in order to common flame quenching problems in meso/micro scale burning. Numerical simulations using Computational Fluid Dynamic (CFD) Ansys Release 19.0 Academic program was performed to determine a stable combustion flame. Combustor chamber made from two steps, first step diameter 6 mm with 4 mm depth, second step diameter size 8mm with 5 mm depth. This simulation used mixture of propane fuel-air. The fuel is fed through two channels of fuel inlet with 2 mm diameter. The variable of fuel flow rate was investigated in order to get the boundary of extinction limit and blow off limit of flame (stable flame region). The results show that the flame stable limit by using meso-scale vortex combustor more widely than other types of micro combustor. Therefore, the meso-scale vortex combustor that was developed could be used to overcome the flame quenching problems.
The oxidizer is used in aviation propellants for its relatively high impulse density and non-toxic nature. At elevated temperatures, nitrous oxide (N₂O) decomposes into approximately 33% oxygen (O₂) and 67% nitrogen (N₂), providing a higher oxygen content than ambient air. This decomposition enables N₂O to produce higher flame temperatures than air. Previous studies have shown that N₂O addition improves flame stability in methane combustion systems. This study examined the substitution of O₂ with N₂O in stoichiometric methane–air premixed flames, using both numerical and experimental methods. One-dimensional and two-dimensional simulations with CHEMKIN PRO revealed that replacing air with N₂O increases flame temperature but reduces laminar flame speed, mainly due to lower local oxygen concentrations in the reaction zone. The simulations also showed that nitrogen oxides (NOₓ) emissions increase significantly in the post-reaction zone, while carbon monoxide (CO) and carbon dioxide (CO₂) emissions decrease. Experimental results confirmed that controlled N₂O addition enhances flame stability, but excessive concentrations can trigger combustion instabilities. Overall, the findings indicate that introducing up to 20% N₂O can increase flame temperature and reduce CO emissions in methane flames.