Visible‐light‐driven photocatalytic oxidation by photogenerated holes has immense potential for environmental remediation applications. While the electron‐mediated photoreduction reactions are often at the spotlight, active holes possess a remarkable oxidation capacity that can degrade recalcitrant organic pollutants, resulting in nontoxic byproducts. However, the random charge transfer and rapid recombination of electron–hole pairs hinder the accumulation of long‐lived holes at the reaction center. Herein, a novel method employing defect‐engineered indium (In) single‐atom photocatalysts with nitrogen vacancy (Nv) defects, dispersed in carbon nitride foam (In‐Nv‐CNF), is reported to overcome these challenges and make further advances in photocatalysis. This Nv defect‐engineered strategy produces a remarkable extension in the lifetime and an increase in the concentration of photogenerated holes in In‐Nv‐CNF. Consequently, the optimized In‐Nv‐CNF demonstrates a remarkable 50‐fold increase in photo‐oxidative degradation rate compared to pristine CN, effectively breaking down two widely used antibiotics (tetracycline and ciprofloxacin) under visible light. The contaminated water treated by In‐Nv‐CNF is completely nontoxic based on the growth of Escherichia coli. Structural–performance correlations between defect engineering and long‐lived hole accumulation in In‐Nv‐CNF are established and validated through experimental and theoretical agreement. This work has the potential to elevate the efficiency of overall photocatalytic reactions from a hole‐centric standpoint.
The attainment of high-protein-retention and low-protein-fouling membranes is crucial for industries that necessitate protein production or separation process. The present study aimed to develop a novel method for preparing polyacrylonitrile (PAN) membranes possessing a highly hydrophilic and negatively charged surface as well as interior structure. The method involved a pre-hydrolysis treatment during the preparation of the PAN dope solution, followed by phase inversion in an alkaline solution. Chemical and material characterization of the dopes and membranes uncovered that the cyclized PAN structure served as a reaction intermediate that facilitated strong hydrolysis effect during phase inversion and homogeneously formed carboxyl groups in the membrane’s interior structure. The resulting membrane showed a highly hydrophilic surface with a contact angle of 12.4° and demonstrated less than 21% flux decay and more than 95% flux recovery during multi-cycle filtration of bovine serum albumin (BSA) solution, with a high protein rejection rate of 96%. This study offers a facile and effective alternative for preparing PAN membranes with enhanced antifouling and protein-retention properties.
While numerous persulfate‐based advanced oxidation processes (AOPs) have been studied based on fancy catalysts, the practical combination of Fe or Mn modified granular activated carbon (GAC) has seldom been investigated. The present study focused on a green and readily synthesized Fe−Mn bimetallic oxide doped GAC (Fe−Mn@GAC), to uncover its catalytic kinetics and mechanism when used in the peroxydisulfate (PDS)‐based oxidation process for degrading Rhodamine B (RhB), a representative xenobiotic dye. The synthesized Fe−Mn@GAC was characterized by SEM‐EDS, XRD, ICP‐OES and XPS analyses to confirm its physicochemical properties. The catalytic kinetics of Fe−Mn@GAC+PDS system were evaluated under varying conditions, including PDS and catalyst dosages, solution pH, and the presence of anions. It was found Fe−Mn@GAC exhibited robust catalytic performance, being insensitive to a wide pH range from 3 to 11, and the presence of anions such as Cl−, SO42−, NO3− and CO32−. The catalytic mechanism was investigated by EPR and quenching experiments. The results indicated the catalytic system processed a non‐radical oxidation pathway, dominated by direct electron transfer between RhB and Fe−Mn@GAC, with singlet oxygen (1O2) playing a secondary role. The catalytic system also managed to maintain a RhB removal above 81 % in successive 10 cycles, and recover to 89.5 % after simple DI water rinse, showing great reusability. The catalytic system was further challenged by real dye‐containing wastewater, achieving a decolorization rate of 84.5 %. This work not only provides fresh insight into the kinetics and mechanism of the Fe−Mn@GAC+PDS catalytic system, but also demonstrates its potential in the practical application in real dye‐containing wastewater treatment.