Particle shape affects the mechanical behavior of soils, including packing density, stiffness, volume change during shear, and strength. Laboratory experiments conducted to study the mechanical response of sand mixtures made of round and angular grains show an increase in void ratio, small strain shear modulus Gmax (constant fabric), oedometric compressibility CC (fabric changes), and friction angle but a decrease in lateral stress coefficient k0 as the mass fraction of angular particles increases. These results reflect variations in particle mobility and highlight the relative role of contact stiffness versus fabric changes.
Rainfall during summer season is one of the major causes of slope failure in Korea, especially in unsaturated weathered granite soils. The current slope design procedure for the rainy season is to just raise the ground-water level, which is not adequate for the unsaturated soil slope. Previous rainfall hazard envelopes only tend to use rainfall intensity and duration as the main variables, not considering mechanical and hydraulic characteristics of unsaturated soils. The general equation for Factor of Safety (FS) in infinite unsaturated slopes is derived to consider the rainfall infiltration. The three important factors governing the equation are as follows: rainfall characteristics such as intensity and duration to determine a wetting front depth using an infiltration model, shear strength theory for unsaturated soil, and variation of suction profile during rainfall. The minimal FS is calculated from the FS profile with depth for a given rainfall intensity and duration, and a rainfall hazard envelope considering soil infiltration characteristics is built for a given slope angle. The procedure to develop a hazard envelope for various slope angles is applied to three unsaturated weathered granite soils in Korea.
1 January 2016 in Journal of the Korean Association of Oral and Maxillofacial Surgeons
Soil depth is a crucial parameter in slope stability analysis in mountainous areas. The drilling survey is the most reliable method for determining soil depth, but it requires a high cost for the vast geographical area. Therefore, this study proposes a soil depth prediction model for mountainous areas that uses Terrain Attributes (TAs) from digital maps. Gangwon-Do, a predominantly mountainous region in South Korea, is selected as the study target area. The study area is classified by parent rock type into igneous rocks, metamorphic rocks, and sedimentary rocks. The correlation with TAs is analyzed through multi-collinearity using drilling data published in the Korea drilling information database. In addition, the most suitable combination of variables is selected through multi-collinearity analysis, and the regression model using STI, TWI, and SLOPE is found to be the most appropriate model (VIF < 10). The proposed model for soil depth shows significance at p < 0.001, and the correlation coefficient () is figured out for igneous rock (0.702), metamorphic rock (0.686), and sedimentary rock (0.693). In addition, the reliability of the proposed model was verified by using data from regions not included in the model development, and the correlation coefficients were igneous rock (0.867), metamorphic rock (0.801), and sedimentary rock (0.814). The model proposed is more suitable for Korean topography than the existing statistical models; it can help to increase the accuracy of slope stability analysis.