Industrial wastewater discharge is well acknowledged to constitute a significant environmental and public health risk. In addition, synthetic dyes used in the textile sector are major culprits in water pollution. The amount of water polluted by these dyes is simply staggering. We urgently address this issue to protect our planet and health. The degradation of indigo carmine dye in the presence of Sm3+-doped ZnS nanoparticles is reported in this study and characterized by XRD, FTIR, SEM, EDX, TEM, BET, PL, UV, etc. The particle size calculated from the Scherrer equation was 3–12 nm. When excited at 395 nm, Sm3+ undergoes f–f transitions, which are visible as prominent peaks in the photoluminescence spectrum at 559, 595, and 642 nm wavelengths. The catalyst showed vigorous catalytic activity for dye degradation, with a 93% degradation rate when used at 15 mg/L catalyst within 210 min. The reaction was found to have pseudo-first-order kinetics. After applying the Freundlich and Langmuir data, the Langmuir isotherm offered the best fit. The findings indicate that the Sm3+-doped ZnS catalyst might be successfully used in the degradation of dyes present in the environment. Doping with Sm3+ ions can significantly change the photocatalytic breakdown of indigo carmine and the luminescence characteristics of ZnS.
30 January 2024 in Brazilian Journal of Chemical Engineering
The reflux technique was used to synthesize praseodymium-doped cadmium sulfide nanoparticles (Pr3+: CdS) with different doping concentrations 0, 5, 7, 9 and 11 at %. According to X-ray diffraction the samples were crystalline and hexagonal phase. Agglomerations of nanoparticles were observed from scanning electron microscopy image. When excited at 423 nm transitions of 3P1 → 3H5, 3P0 → 3H5, 3P0 → 3H6, 3P0 → 3F2 are obtained from the photoluminescence studies. The position, sharpness, and intensity increased with increase in concentration. Commission internationale de l’eclairage diagram shows that Pr3+ doped CdS had a hue almost white light, indicating that it might be used for solid-state illumination. For degrading methylene blue and methyl red, it was found that catalyst dose of 5 mg/L, pH 9 and pH 11 shows the best degradation percentage which is 89 and 94% respectively. Pr3+ doping enhanced methyl red and methylene blue degradation by photocatalyst. The experimental data matched both the Langmuir–Hinshelwood (L–H) and pseudo-first-order kinetics models. At the same ideal experimental conditions, the pseudo-first-order provided a better fit than the Langmuir–Hinshelwood kinetic model. The research suggests that Pr3+ doped CdS may operate effectively as a photocatalyst to detoxify harmful colors from wastewater.
3 August 2020 in International Journal of Applied Ceramic Technology