Danilo Galluzzo

Dr. Danilo Galluzzo


Research Focus & Metrics

Academic Career Length

17Years (2010-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
5 June 2010 in Journal of Geophysical Research
Verified
Journal Article
Open access
PDF file
MRMario La Rocca
Mario La Rocca
DGDanilo Galluzzo
Danilo Galluzzo
SMSteve Malone
Steve Malone
WMWendy McCausland
Wendy McCausland
Edoardo Del PezzoEdoardo Del Pezzo
Edoardo Del Pezzo
We describe a new method to estimate the S‐P time of tremor‐like signals and its application to the nonvolcanic tremor recorded in July 2004 by three dense arrays in Cascadia. The cross correlation between vertical and horizontal components indicates that very often the high‐amplitude tremor signal contains sequences of P and S waves characterized by constant S‐P times (TS‐P) in the range 3.5–7 s. A detailed observation of the three component seismograms stacked over the array stations confirms the presence of P and S wave sequences. The knowledge of the TS‐P poses a strong constrain on the source‐array distance, which dramatically reduces the uncertainty on source locations when used with more traditional array processing techniques. Data were analyzed using the zero lag cross‐correlation technique (ZLCC) to estimate the propagation properties of the most correlated phases in the wavefield. Detailed polarization analyses were computed using the covariance matrix method in the time domain. Polarization parameters, joint with the results of ZLCC, allows for the discrimination between P and S coherent waves. Results show that the tremor wavefield is composed mostly by shear waves, although a consistent amount of coherent P waves is often observable. The comparison of the back azimuth at the three arrays indicate that the source of deep tremor migrates over a wide area, and often many independent sources located far from each other are active at the same time. The tremor source was located by a probabilistic method that uses the results of ZLCC, given a velocity model. When available, the inclusion of the TS‐P time in the location procedure strongly reduces the depth range, with a distribution of hypocenters very near the subduction interface. This result, significantly different compared with previous less precise locations, makes the Cascadia nonvolcanic tremor more similar to the nonvolcanic tremor recorded in Japan, at least in cases of measurable TS‐P. The polarization azimuth aligned with the slow slip direction and the source located on the plate interface indicate that deep tremor and slow slip are two different manifestations of a common phenomenon related with the subduction dynamics.

30 September 2016 in Annals of Geophysics
Verified
Journal Article
Open access
PDF file
LZLuciano Zuccarello
Luciano Zuccarello
MPMario Paratore
Mario Paratore
MRMario La Rocca
Mario La Rocca
FFFerruccio Ferrari
Ferruccio Ferrari
AMAlfio Messina
Alfio Messina
LMLuz García Martínez
Luz García Martínez
Seismic noise recorded by a temporary array installed around Pozzo Pitarrone, NE flank of Mt. Etna, have been analysed with several techniques. Single station HVSR method and SPAC array method have been applied to stationary seismic noise to investigate the local shallow structure. The inversion of dispersion curves produced a shear wave velocity model of the area reliable down to depth of about 130 m. A comparison of such model with the stratigraphic information available for the investigated area shows a good qualitative agreement. Taking advantage of a borehole station installed at 130 m depth, we could estimate also the P-wave velocity by comparing the borehole recordings of local earthquakes with the same event recorded at surface. Further insight on the P-wave velocity in the upper 130 m layer comes from the surface reflected wave observable in some cases at the borehole station. From this analysis we obtained an average P-wave velocity of about 1.2 km/s, compatible with the shear wave velocity found from the analysis of seismic noise.

28 February 2023 in Bulletin of the Seismological Society of America
Verified
Journal Article
Closed access
PDF file
MRMario La Rocca
Mario La Rocca
DGDanilo Galluzzo
Danilo Galluzzo
LNLucia Nardone
Lucia Nardone
GGGuido Gaudiosi
Guido Gaudiosi
Francesca Di LuccioFrancesca Di Luccio
Francesca Di Luccio
Mefite d’Ansanto (Italy) is a nonvolcanic field characterized by persistent strong degassing activity. A seismic field monitoring carried out during the Summer 2021 reveals a persistent, extended, and complex source of seismic tremor characterized by a spectrum with a frequency content from about 1 Hz to more than 35 Hz. While at frequency smaller than 3 Hz the signal amplitude is stationary, in the intermediate frequency band (3–20 Hz) sudden changes of amplitude are often observed, suggesting the existence of an intermittent source (every few minutes to tens of minutes). Furthermore, very short bursts of high-frequency energy are recognized in the tremor signal. Results of array analysis and seismological observation indicate that the sources of the analyzed tremor are located in a small area centered on the main vent of the degassing area. The persistent low-frequency tremor and the intermediate frequency signals propagate as surface waves to the seismic stations installed around the source and indicate a very shallow source. On the contrary, impulsive signals at frequencies greater than 20 Hz propagate as body waves, revealing a deeper source likely located between 50 and 100 m depth.

1 May 2016 in Earth and Planetary Science Letters
Verified
Journal Article
Closed access
MRMario La Rocca
Mario La Rocca
DGDanilo Galluzzo
Danilo Galluzzo

27 October 2020 in Advances in Geosciences
Verified
Journal Article
Open access
PDF file
DGDanilo Galluzzo
Danilo Galluzzo
LNLucia Nardone
Lucia Nardone
MRMario La Rocca
Mario La Rocca
AEAntonietta M. Esposito
Antonietta M. Esposito
RMRoberto Manzo
Roberto Manzo
RMRosa Di Maio
Rosa Di Maio
Spectral analysis has been applied to almost thousand seismic events recorded at Vesuvius volcano (Naples, southern Italy) in 2018 with the aim to test a new tool for a fast event classification. We computed two spectral parameters, central frequency and shape factor, from the spectral moments of order 0, 1, and 2, for each event at seven seismic stations taking the mean among the three components of ground motion. The analyzed events consist of volcano-tectonic earthquakes, low frequency events and unclassified events (landslides, rockfall, thunders, quarry blasts, etc.). Most of them are of low magnitude, and/or low maximum signal amplitude, therefore the signal to noise ratio is very different between the low noise summit stations and the higher noise stations installed at low elevation around the volcano. The results of our analysis show that volcano-tectonic earthquakes and low frequency events are easily distinguishable through the spectral moments values, particularly at seismic stations closer to the epicenter. On the contrary, unclassified events show the spectral parameters values distributed in a broad range which overlap both the volcano-tectonic earthquakes and the low frequency events. Since the computation of spectral parameters is extremely easy and fast for a detected event, it may become an effective tool for event classification in observatory practice.

2 February 2023 in Sensors
Verified
Journal Article
Open access
PDF file
SMSimona Morabito
Simona Morabito
PCPaola Cusano
Paola Cusano
DGDanilo Galluzzo
Danilo Galluzzo
GGGuido Gaudiosi
Guido Gaudiosi
LNLucia Nardone
Lucia Nardone
Francesca Di LuccioFrancesca Di Luccio
Francesca Di Luccio
A passive seismic experiment is carried out at the non-volcanic highly degassing site of Mefite d’Ansanto located at the northern tip of the Irpinia region (southern Italy), where the 1980 MS 6.9 destructive earthquake occurred. Between 2020 and 2021, background seismic noise was recorded by deploying a broadband seismic station and a seismic array composed of seven 1 Hz three-component sensors. Using two different array configurations, we were allowed to explore in detail the 1–20 Hz frequency band of the seismic noise wavefield as well as Rayleigh wave phase velocities in the 400–800 m/s range. Spectral analyses and array techniques were applied to one year of data showing that the frequency content of the signal is very stable in time. High frequency peaks are likely linked to the emission source, whereas at low frequencies seismic noise is clearly correlated to meteorological parameters. The results of this study show that small aperture seismic arrays probe the subsurface of tectonic CO2-rich emission areas and contribute to the understanding of the link between fluid circulation and seismogenesis in seismically active regions.