Background: Guided bone regeneration (GBR) is a widely used procedure for augmenting alveolar ridge width prior to placement of endosseous implants. Various graft materials and barrier membranes (non‐resorbable and bioabsorbable) have been used in GBR. The aim of this study was to assess the performance of a new bioabsorbable, synthetic polyglycolic acid/trimethylene carbonate (PGA/TMC) barrier membrane with an increased absorption time in conjunction with a combination of assayed demineralized bone matrix and cortical cancellous chips uniformly dispersed in a thermoplastic biologic carrier.Methods: At 72 potential implant sites in 38 subjects, ridge width at the crest and 4 mm apical to the crest was measured before and 6 months after a GBR procedure using the long‐term (LT) PGA/TMC membrane and an allograft in a thermoplastic carrier. Before placement of endosseous implants, 48 biopsy specimens were obtained from the augmentation sites and analyzed histomorphometrically.Results: The GBR procedure increased the mean ridge width at the crest from 2.4 to 5.2 mm. This 216% change from baseline was significant (P <0.001). The mean width 4 mm apical to the crest increased from 4.4 to 7.5 mm, a significant (P <0.001) 174% change. The histomorphometric analysis showed that the biopsy specimens consisted, on average, of 57% bone (36% graft material and 21% new bone) and 43% soft tissue and space.Conclusion: Our findings suggest that the LT PGA/TMC barrier membrane, used in conjunction with an allograft, provides lateral alveolar ridge augmentation comparable to that achieved with other materials without the necessity for bone‐graft harvesting or a second procedure to remove the barrier membrane.
Introduction: Human histology and scanning electron microscopy (SEM) are presented, outlining the soft tissue integration to a laser microgrooved abutment surface.Case Presentation: In two patients, prosthetic abutments with a laser microgrooved surface were placed on osseointegrated implants. After 6 weeks of healing, the abutments and the surrounding soft tissue were removed and prepared for histology and SEM. The most apical epithelium was found coronal to this surface. Connective tissue demonstrated collagen fibers oriented perpendicular to the microgrooved surface. There was intimate contact between the connective tissues and the microgrooved abutment surface.Conclusion: The abutments in these patients had connective tissue integration with functionally oriented fibers to the microgrooved surface.
Focused Clinical Question: The integration of connective tissue (CT) to a laser‐ablated abutment with a microgrooved surface at the apical millimeter (LL) has been documented in both animal and human studies. How should the healing be influenced to optimize the CT integration on abutment surfaces?Summary: When smooth machined titanium (ST) abutments were placed, epithelial attachment was found on abutments, but no CT integration was noted. On LL abutments, a zone of epithelial attachment and CT integration was noted. When an ST abutment was switched for an LL abutment, the soft tissue was inconsistent; however, when an LL abutment was placed after the removal of a prior LL abutment, CT integration was observed.Conclusions: Consistent CT integration was observed on LL abutment surfaces after implant placement. Switching LL abutments with new LL abutments consistently led to CT integration. This was not consistent when an ST abutment was switched for an LL abutment. Plaque and gingival indices were comparable between teeth and abutments. Probing depth (PD) was lower around teeth. There was no difference in PD between abutments. CT integration on LL abutments was optimized by initial healing occurring on an LL abutment or by creation of a CT wound before insertion of the abutment.