A brief review of crack path calculation methods using integral principles of mechanics is presented. In twodimensional setting, a crack is considered as a geodesic line on the surface of a body with a metric that depends on the initial stress state. The possibility of approximate determination of crack path on the basis of integral principles is illustrated on a number of problems. In particular, crack paths in a half-plane under uniformly distributed load applied on its edge are determined. The calculations include the stress state of the half-plane taken from the solution for a body without a crack. The fruitfulness of the representation of displacements of crack edges using the Winkler’s hypothesis is shown. To study the subcritical behavior of the crack, the concept of cracon, a quasi-particle simulating the motion of the crack tip, can be introduced. The problem of determining the crack path on the basis of integral principles of mechanics is insufficiently investigated and requires further research.
14 September 2022 in Bulletin of Kazakh Leading Academy of Architecture and Construction
When designing the optimal compositions of concretes and mortars, the most important step is to conduct an active experiment, which establishes the dependence of consumer properties of concretes and mortars on structural characteristics. At this stage of research, it is very important to correctly apply the relationship between the structural characteristics, the values of which we are asking. We establish these values by preliminary point experiments to obtain maximum effects of their influence on the final properties of concrete.
In the article [1], we propose a new fracture criterion based on the assumption that brittle fracture occurs when the deformation gradient modulus reaches a limit value. We consider in more detail the fact that the modulus of the temperature gradient, and, consequently, that of the deformation, becomes significant in a thin boundary layer where a quick temperature change occurs. We also present the solution of a new thermoelastic problem of a quick temperature change in a circular area. As it turned out, in the case of a curved boundary of the cooled area E2, where E2 is the Euclidean plane, the fracture criterion becomes complicated and gets a form of a limit value of the gradient modulus of the main deformations sum or just of the main stresses sum. Destruction is determined by the criterion the time of which setting in is less. It is also shown in the aticle that in the case of a heated circular area in E2 the criterion for brittle fracture of a continuum medium is the limit value of the gradient modulus of the main deformations sum. The results of the preliminary experiment with organic glass samples during a quick temperature change in the area with a rectilinear boundary are presented. During the experiment, there appeared a crack along the boundary of the temperature leap, although the stresses across this boundary are equal to zero, but there is a significant deformation gradient.
4 July 2022 in Herald of the Kazakh-British technical university
The work is devoted to the application of the concept of specific strength for the analysis of the degree of utilization of mechanical properties of beam material under combined loading. The beam is studied and force diagrams are constructed for various types of loads, such as pure bending with tension, pure bending with tension and torsion, pure bending with torsion, and the strength utilization factor of a beam with an arbitrary cross-section is obtained. The research method is based on the superposition of stress states with the determination of the difference between the resistance diagrams. The concept of material resistance to fracture in the form of ultimate stresses distributed over the body volume is introduced. The method of calculating the specific strength for a beam under combined stress, as well as for thick-walled pipes loaded with internal pressure, is given. The relationship between the beam cross-section of the beam and the specific strength is presented, followed by a conclusion for the optimal application of the beam with the cross-section used.