Timothy Lau

Dr. Timothy Lau

orcid

Research Focus & Metrics

Academic Career Length

14Years (2013-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
19 September 2014 in Journal of Fluid Mechanics
Verified
Journal Article
Closed access
PDF file
TLTimothy Lau
Timothy Lau
GNGraham J. Nathan
Graham J. Nathan
The first measurement of the influence of the Stokes number on the distributions of particle concentration and velocity at the exit of a long pipe are reported, together with the subsequent influence on the downstream evolution of these distributions through a particle-laden jet in co-flow. The data were obtained by simultaneous particle image velocimetry (PIV) and planar nephelometry (PN), using four cameras to provide high resolution through the first 30 jet diameters and also correction for optical attenuation. These data provide much more detailed information than is available from previous measurements. From them, a new understanding is obtained of how the Stokes number influences the flow at the jet exit plane and how this influence propagates throughout the jet.

9 November 2016 in Journal of Fluid Mechanics
Verified
Journal Article
Closed access
PDF file
TLTimothy Lau
Timothy Lau
GNGraham J. Nathan
Graham J. Nathan
Simultaneous measurements of particle velocity and concentration (number density) in a series of mono-disperse, two-phase turbulent jets issuing from a long, round pipe into a low velocity co-flow were performed using planar nephelometry and digital particle image velocimetry. The exit Stokes number, $Sk_{D}$ , was systematically varied over two orders of magnitude between 0.3 and 22.4, while the Reynolds number was maintained in the turbulent regime ( $10\,000\leqslant Re_{D}\leqslant 40\,000$ ). The mass loading was fixed at $\unicode[STIX]{x1D719}=0.4$ , resulting in a flow that is in the two-way coupling regime. The results show that, in contrast to all previous work where a single Stokes number has been used to characterise fluid–particle interactions, the characteristic Stokes number in the axial direction is lower than that for the radial direction. This is attributed to the significantly greater length scales in the axial motions than in the radial ones. It further leads to a preferential response of particles to gas-phase axial velocity fluctuations, $u_{p}^{\prime }$ , over radial velocity fluctuations, $v_{p}^{\prime }$ . This, in turn, leads to high levels of anisotropy in the particle-phase velocity fluctuations, $u_{p}^{\prime }/v_{p}^{\prime }>1$ , throughout the jet, with $u_{p}^{\prime }/v_{p}^{\prime }$ increasing as $Sk_{D}$ is increased. The results also show that the region within the first few diameters of the exit plane is characterised by a process of particle reorganisation, resulting in significant particle migration to the jet axis for $Sk_{D}\leqslant 2.8$ and away from the axis for $Sk_{D}\geqslant 5.6$ . This migration, together with particle deceleration along the axis, causes local humps in the centreline concentration whose value can even exceed those at the exit plane.

28 October 2013 in Journal of Fluid Mechanics
Verified
Journal Article
Closed access
PDF file
SCSarah D. Crook
Sarah D. Crook
TLTimothy Lau
Timothy Lau
RKRichard M. Kelso
Richard M. Kelso
The three-dimensional structure of incompressible flow in a narrow, open rectangular cavity in a flat plate was investigated with a focus on the flow topology of the time-averaged flow. The ratio of cavity length (in the direction of the flow) to width to depth was $l{: }w{: }d= 6{: }2{: }1$ . Experimental surface pressure data (in air) and particle image velocimetry data (in water) were obtained at low speed with free-stream Reynolds numbers of ${\mathit{Re}}_{l} = 3. 4\times 1{0}^{5} $ in air and ${\mathit{Re}}_{l} = 4. 3\times 1{0}^{4} $ in water. The experimental results show that the three-dimensional cavity flow is of the ‘open’ type, with an overall flow structure that bears some similarity to the structure observed in nominally two-dimensional cavities, but with a high degree of three-dimensionality both in the flow near the walls and in the unsteady behaviour. The defining features of an open-type cavity flow include a shear layer that traverses the entire cavity opening ultimately impinging on the back surface of the cavity, and a large recirculation zone within the cavity itself. Other flow features that have been identified in the current study include two vortices at the back of the cavity, of which one is barely visible, a weak vortex at the front of the cavity, and a pair of counter-rotating streamwise vortices along the sides of the cavity near the cavity opening. These vortices are generally symmetric about the cavity centre-plane. However, the discovery of a single tornado vortex, located near the cavity centreline at the front of the cavity, indicated that the flow within the cavity is asymmetric. It is postulated that the observed asymmetry in the time-averaged flow field is due to the asymmetry in the instantaneous flow field, which switches between two extremes at large time scales.

9 August 2022 in Applied Thermal Engineering
Verified
Journal Article
Closed access
SRSoheila Riahi
Soheila Riahi
MBMartin Belusko
Martin Belusko
TLTimothy Lau
Timothy Lau
RFRoss Flewell-Smith
Ross Flewell-Smith
MEMichael Evans
Michael Evans
FBFrank Bruno
Frank Bruno

4 October 2023 in Journal of Loss Prevention in the Process Industries
Verified
Journal Article
Open access
Hengrui LiuHengrui Liu
Hengrui Liu
Fatemeh SalehiFatemeh Salehi
Fatemeh Salehi
RARouzbeh Abbassi
Rouzbeh Abbassi
TLTimothy Lau
Timothy Lau
Guan Heng YeohGuan Heng Yeoh
Guan Heng Yeoh
VRVenkat Raman
Venkat Raman