This paper presents the design specifications of an experimental setup capable of injecting faults in a synchronous generator to develop and test algorithms for condition based maintenance of aerospace applications. A 3 kVA alternator is designed to inject faults in the stator winding and field windings. The system is capable of injecting open and short circuit faults in the stator and rotor windings using a fault injection unit and record current, voltage and vibration signals from the respective sensors, with programming capability. The response of the synchronous generator during normal condition and faulty condition are discussed. The work reported in this paper will help other researchers develop low cost experimental facility to pursue research in machine condition monitoring.
27 September 2021 in Measurement Science and Technology
In the recent years, non-intrusive load monitoring (NILM) technique has received much attention among researchers because of its effective monitoring of events and extraction of energy consumption of individual loads from aggregated energy consumption. The performance of the existing NILM algorithms may not be adequate while multiple similar type/same kind of loads are connected in an electrical network which cause overlapping of signatures of the individual loads of similar type/same kind. In the present study, multiple air conditioners of same model from the three different makes have been considered for NILM in a commercial/residential environment. Preliminary investigations by considering the general features such as apparent power and power factor for the purpose of load classification indicated that there is scope for improvement in their performance of the load classification. Hence, a new feature set consisting of power and intrinsic features which are derived from the electrical signals during transient and steady state operation of the loads has been proposed. The geometric mean between all the considered electrical features has been computed to capture the relationship between the features for more effective load classification. These studies with the new feature set indicated enhanced performance in load classification of same model and same make. Further, a feature mapping technique, viz. locality constrained linear coding (LLC) has been explored to represent the new set of features as a linear combination of basis vectors to make the features load independent for further improving the performance of load classification of loads of same model and same make. These additional studies indicated that the LLC based approach achieved further enhanced performance as compared to the baseline systems for load classification of loads of same model and same make in NILM systems.
Support Vector Machine (SVM) is an important machine learning algorithm widely used for the development of machine fault diagnosis systems. In this work, we use an SVM back-end classifier, with statistical features in time and frequency domain as its input, for the development of a fault diagnosis system for a rotating machine. Our baseline system is evaluated for its speed dependent and speed independent performances. In this paper, we use locality constrained linear coding (LLC) to map the input feature vectors to a higher dimensional linear space, and remove some of the speed specific dimensions to improve the speed independent performance of the fault diagnosis system. We use LLC to do the feature mapping to the higher dimensional space, and select only the k nearest neighbour basis vectors to represent the input feature vector and thus reduce/minimize the effect of speed specific factors from the input feature vector, and thus improve the speed independent performance of the fault diagnosis. We compare the performance of the LLC-SVM system for the time and frequency domain statistical features. The proposed approach has improved the overall classification accuracy by 11.81% absolute for time domain features and 10.53% absolute for frequency domain features compared to the baseline speed independent system.