A 5-day in vivo rat model was evaluated as an approach to estimate chemical exposures that may pose minimal risk by comparing benchmark dose (BMD) values for transcriptional changes in the liver and kidney to BMD values for toxicological endpoints from traditional toxicity studies. Eighteen chemicals, most having been tested by the NTP in 2-year bioassays, were evaluated. Some of these chemicals are potent hepatotoxicants (e.g. DE71, PFOA, and furan) in rodents, some exhibit toxicity but have minimal hepatic effects (e.g. acrylamide and α,β-thujone), and some exhibit little overt toxicity (e.g. ginseng and milk thistle extract) based on traditional toxicological evaluations. Male Sprague Dawley rats were exposed once daily for 5 consecutive days by oral gavage to 8-10 dose levels for each chemical. Liver and kidney were collected 24 hours after the final exposure and total RNA was assayed using HTT with the rat S1500+ platform. HTT data were analyzed using BMD Express 2 to determine transcriptional gene set BMD values. BMDS was used to determine BMD values for histopathological effects from chronic or sub-chronic toxicity studies. For many of the chemicals, the lowest transcriptional BMDs from the 5-day assays were within a factor of 5 of the lowest histopathological BMDs from the toxicity studies. These data suggest that using HTT in a 5-day in vivo rat model provides reasonable estimates of BMD values for traditional apical endpoints. This approach may be useful to prioritize chemicals for further testing while providing actionable data in a timely and cost-effective manner.
Macrophage-solubilized indium-containing particles (ICPs) were previously shown in vitro to be cytotoxic. In this study, we compared macrophage solubilization and cytotoxicity of indium phosphide (InP) and indium-tin oxide (ITO) with similar particle diameters (∼1.5 µm) and then determined if relative differences in these in vitro parameters correlated with pulmonary toxicity in vivo. RAW 264.7 macrophages were treated with InP or ITO particles and cytotoxicity was assayed at 24 h. Ionic indium was measured in 24 h culture supernatants. Macrophage cytotoxicity and particle solubilization in vitro were much greater for InP compared with ITO. To correlate changes in vivo, B6C3F1 mice were treated with InP or ITO by oropharyngeal aspiration. On Days 14 and 28, bronchoalveolar lavage (BAL) and pleural lavage (PL) fluids were collected and assayed for total leukocytes. Cell differentials, lactate dehydrogenase activity, and protein levels were also measured in BAL. All lavage parameters were greatly increased in mice treated with InP compared with ITO. These data suggest that macrophage solubilization and cytotoxicity of some ICPs in vitro are capable of predicting pulmonary toxicity in vivo. In addition, these differences in toxicity were observed despite the two particulate compounds containing similar amounts of indium suggesting that solubilization, not total indium content, better reflects the toxic potential of some ICPs. Soluble InCl3 was shown to be more cytotoxic than InP to macrophages and lung epithelial cells in vitro further suggesting that ionic indium is the primary cytotoxic component of InP.
Inhalation exposure to diacetyl (DA) is associated with obliterative bronchiolitis (OB) in workers and induces OB-like fibrotic airway lesions in rats. The pathogenesis of OB is poorly understood in part due to complex interactions between airway epithelial, mesenchymal and blood-derived inflammatory cells. DA-induced airway toxicity in the absence of recruited-inflammatory/immune cells was characterized using an air-liquid interface (ALI) model consisting of human airway epithelium with (Epi/FT) and without (Epi) a mesenchymal component. ALI cultures were exposed to 25 mM DA-derived vapors (using vapor cups) for 1 h on day 0, 2 and 4. In some experiments, the tissues were exposed to 2,3-hexanedione (Hex) which is structurally-similar, but much less fibrogenic than DA. Lactate dehydrogenase activity and day 6 histopathologic changes associated with epithelial injury, including basal/suprabasal spongiosis, were increased following exposure of Epi/FT tissues to DA but not control or Hex vapors. IL-1a, IL-6, IL-8, sIL-1Ra, TGFa, MCP-3 and TNFa proteins were increased following DA exposure of Epi/FT tissues; only IL-1a, IL-8, sIL-1Ra and TGFa were increased following exposure of Epi tissues. MMP-1, MMP-3 and TIMP-1 proteins were increased following DA exposure of Epi/FT tissues; whereas MMP-2, MMP-7 and TIMP-2 were decreased, and production was largely dependent upon the presence of sub-epithelial stromal matrix/fibroblasts. Hex-induced protein changes were minimal. This in vitro study demonstrated that exposure of human airways to DA vapors induced epithelial injury (with the histopathologic feature of basal/suprabasal spongiosis) and increased release of pro-inflammatory and pro-fibrotic cytokines/chemokines as well as MMPs/TIMPs in the absence of recruited-inflammatory cells.
Indium-tin oxide (ITO) is a solid mixture often comprised of approximately 90% indium oxide and 10% tin oxide by weight. ITO is employed as a transparent conductive coating for flat panel, liquid crystal, and plasma displays and is typically deposited after sintering as a thin film on a substrate through a variety of processes. Unfortunately, there have been published reports of workers who have been adversely impacted through exposure to this compound. When these reports are coupled with the industrial utility of ITO, future toxicological investigations are likely. Comprehensive characterization of ITO test materials would be an essential component of these studies. Ideally, characterization would include assessment of ITO particle size as administered during dosing because this physicochemical parameter can significantly impact solubility. The objective of this task was to develop, optimize, and apply a dynamic light scattering (DLS) sample preparation and measurement protocol for determination of particle size for a suite of sintered/non-sintered ITO samples prepared in cellular growth media at nominal 0.3 mg/mL doses. Sonication time was evaluated from 15 to 90 minutes over a 24-hour, continuous DLS measurement period. Resulting suspensions from samples subjected to 30 minute sonication times were stable with respect to hydrodynamic particle size between 10 and 24 hours after sonication. Throughout the 24-hour DLS measurement period, suspension aliquots were analyzed by inductively coupled plasma mass spectrometry to determine indium concentration. The developed protocol enabled investigators to use ITO suspensions of known hydrodynamic particle size and concentration in their in vitro cellular study.