The transition of additive manufacturing (AM) from a technique for rapid prototyping to one for manufacturing of near net or net components has been led by the development of methods that can repeatedly fabricate quality parts. High-speed laser sintering and the recently developed multi-jet fusion (MJF) processes have seen quick adoption from industry due to their ability to produce high-quality components relatively quickly. However, the recommended refresh ratios of new powder led to notable amounts of used powder being discarded. In this research, polyamide-11 powder, typically used in AM, was thermally aged to investigate its properties at extreme levels of reuse. The powder was exposed to 180 °C in air for up to 168 h and its chemical, morphological, thermal, rheological, and mechanical properties were examined. To decouple the thermo-oxidative aging phenomena from AM process related effects, such as porosity, rheological and mechanical properties characterisation was performed on compression-moulded specimens. It was found that exposure notably affected the properties of both the powder and the derived compression-moulded specimens within the first 24 h of exposure; however, consecutive exposure did not have a significant effect.
The transition of additive manufacturing (AM) from a technique for rapid prototyping to one for manufacturing of near net or net components has been led by the development of methods that can repeatedly fabricate quality parts. High speed laser sintering and the recently developed multi-jet fusion (MJF) processes have seen quick adoption from industry due to their ability to produce high-quality components relatively fast. However, the recommended refresh ratios of new powder led to notable amounts of used powder being discarded. In this research, polyamide-11 powder, typically used in AM, was thermally aged to investigate its properties at extreme levels of reuse. The powder was exposed to 180 °C in air for up to 168 hours and its chemical, morphological, thermal, rheological, and mechanical properties were examined. To decouple the thermo-oxidative aging phenomena from AM process related effects, such as porosity, rheological and mechanical properties characterisation was performed on compression moulded specimens. It was found that exposure notably affected the properties of both the powder and the derived compression moulded specimens within the first 24 hours of exposure, but consecutive exposure did not have a significant effect.
HP Multi Jet Fusion (MJF) polyamide-11 (PA11) was characterised experimentally and used to calibrate finite element material models for the quasi-static regime. Characterisation covered tension in six build orientations and compression in three. Validation used threepoint bending at XY and YX, and a vertically aligned triply periodic minimal surface (TPMS) gyroid. The flat XY orientation was the anisotropy extreme, carrying a tension–compression yield asymmetry of 30.2% that fell to 14.3% at YX and was negligible at XZ. The modulus asymmetry ran the opposite way, 7% at XY against 20% to 27% elsewhere. Elastic-plastic and asymmetric models were calibrated at the representative YX basis, with XY as the constraining case. Single-stress-state fits deviated by up to 7.8% in the other branch, and the tabular tension-only fit failed outright in compression at YX. At YX the fits carrying both branches held both stress states, the asymmetric formulation trading compressive accuracy for tensile, and at XY it alone held both. In three-point bending the asymmetric YX model matched the experiment, while the XY coupons exceeded both XY-calibrated models, an unexplained flexure elevation. In the gyroid crush the leading YX models reproduced the three-phase response, slightly over-predicting the plateau. YX is recommended as the calibration basis, with the combined-hardening elastic-plastic fit as the general-purpose model. The asymmetric formulation should be considered where bending stiffness governs, on the strength of an empirical rather than mechanistic agreement.